Nissan Juke Service and Repair Manual : Engine stand setting
Preparing the engine to be on the stand
Before the engine is mounted on the engine sub-attachment, the engine's electrical harness must be removed and the engine oil drained.
1. Remove the multifunction support.
2. Remove the coolant inlet pipe on the water pump.
3. Place the rods (A), (X), (Y) on the cylinder block.
Cylinder block
Disassembly and Assembly PREPARING USED ENGINE The engine should be cleaned and drained (oil and water). Leave on the used engine or include in the return box: • Oil filter • Oil pressure switc ...Other materials:
CVT position
Inspection and Adjustment
INSPECTION
1. Turn ON the ignition switch with the selector lever at the P position.
2. Press the selector button with the brake pedal depressed, and confirm that
the lever can be shifted to
positions other than P. Also confirm that shifting is not allowed from the P ...
A/C on signal
Component Function Check
1.CHECK A/C ON SIGNAL
With CONSULT-III
1. Turn ignition switch ON.
2. Operate blower motor.
3. Select “AIR CONDITIONER” of “BCM” using CONSULT-III.
4. Select “AIR COND SW” in “DATA MONITOR” mode.
5. Check A/C ON signal when the A/C switch is operated.
Is the inspec ...
Starting system (without intelligent key)
CVT : Wiring Diagram
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation
of Option Abbreviation".
M/T : Wiring Diagram
For connector terminal arrangem ...