Nissan Juke Service and Repair Manual : Engine overheating

Description

CHART 17: ENGINE OVERHEATING

Diagnosis Procedure

1.CHECK COOLING SYSTEM

Check the cooling system. Refer to CO-60, "Troubleshooting Chart".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace.

2.CHECK ECM POWER SUPPLY AND GROUND CIRCUIT

Check ECM power supply and ground circuit. Refer to EC-885, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace harness or connector.

3.CHECK WIRING HARNESS

Visually check the condition of the engine wiring harness.

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace harness or connector.

4.CHECK ENGINE COOLANT TEMPERATURE SENSOR

Check engine coolant temperature sensor. Refer to EC-908, "Component Inspection".

Is the inspection result normal? Yes >> GO TO 5.

No >> Repair or replace.

5.CHECK COOLING FAN OPERATION

Check cooling fan operation. Refer to EC-1015, "Diagnosis Procedure".

Is the inspection result normal? YES >> INSPECTION END

NO >> Repair or replace.

    Engine knock
    Description CHART 16: ENGINE KNOCK Diagnosis Procedure 1.CHECK ENGINE OIL Check the grade of engine oil. Refer to LU-33, "Inspection". Is the inspection result normal? YES >> G ...

    Engine smokes when started
    Description CHART 18: ENGINE SMOKES WHEN STARTED Diagnosis Procedure 1.CHECK ENGINE OIL Check the grade of engine oil. Refer to LU-33, "Inspection". Is the inspection result normal? ...

    Other materials:

    MR16DDT : Inspection and Adjustment
    INSPECTION Magnetic Switch Check • Before starting to check, disconnect the battery cable from the negative terminal. • Disconnect “M” terminal of starter motor. 1. Continuity test [between “S” terminal (A) and switch body] B : “B” terminal C : “M” terminal • Replace magnetic switch if co ...

    B263D, B263E, B263F intake door motor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE With CONSULT-III 1. Turn ignition switch ON. 2. Select “Self Diagnostic Result” mode of “HVAC” using CONSULT-III. 3. Check DTC. Is DTC detected? YES >> Refer to HAC-159, "Diagnosis P ...

    Front power window switch (passenger side)
    Component Function Check 1. CHECK FRONT POWER WINDOW SWITCH (PASSENGER SIDE) FUNCTION Check front power window motor (passenger side) operation with front power window switch (passenger side). Is the inspection result normal? YES >> INSPECTION END NO >> Refer to PWC-22, "Di ...