Nissan Juke Service and Repair Manual : Engine Mechanical K9K
- Precautions
- Precaution for Procedure without Cowl Top Cover
- Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Draining Engine Coolant
- Disconnecting Fuel Piping
- Removal and Disassembly
- Inspection, Repair and Replacement
- Assembly and Installation
- Parts Requiring Angle Tightening
- Liquid Gasket
- Precaution for Diesel Equipment
- Parts To Be Replaced After Removal
- Installation of Thread Inserts
- Preparation
- Basic inspection
- Periodic maintenance
- Removal and installation
- Air cleaner and air duct
- Charge air cooler
- EGR valve
- Turbocharger
- Exhaust manifold
- Oil pan
- Glow plug
- Vacuum pump
- Injection tube and fuel injector
- 5TH injector
- High pressure supply pump
- Rocker cover
- Timing belt
- Cylinder head
- Unit removal and installation
- Unit disassembly and assembly
- Service data and specifications (SDS)
Precautions
...
Other materials:
Additional service when replacing transaxle assembly
Description
Perform the following work after the transaxle assembly is replaced.
CHECK LOADING OF CALIBRATION DATA
• The TCM acquires calibration data (individual characteristic value) of each
solenoid that is stored in the
ROM assembly (in the control valve). This enables the TCM to perfo ...
Key switch
Component Function Check
1.CHECK FUNCTION
1. Select “DOOR LOCK� of “BCM� using CONSULT-III.
2. Select “KEY ON SW� in “DATA MONITOR� mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Key sw ...
P2127, P2128 APP sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition swit ...

