Nissan Juke Service and Repair Manual : Engine Cooling System MR16DDT
- Precaution
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
- Preparation
- System description
- Symptom diagnosis
- Periodic maintenance
- Radiator
- Removal and installation
- Service data and specifications (SDS)
Service data and specifications
(SDS)
Standard and Limit
OIL PRESSURE
OIL CAPACITY (APPROXIMATE)
TIGHTENING TORQUE
...
Precaution
...
Other materials:
B2098 ignition relay on stuck
Description
• IPDM E/R operates the ignition relay when it receives an ignition switch ON
signal from BCM via CAN communication.
• Turn the ignition relay OFF by pressing the push-button ignition switch once
when the vehicle speed is 4 km/
h (2.5 MPH) or less.
• Turn the ignition relay ...
Camshaft valve clearance
Inspection and Adjustment
INSPECTION
Perform inspection as follows after removal, installation or replacement of
camshaft or valve-related parts, or if
there is unusual engine conditions regarding valve clearance.
1. Remove rocker cover. Refer to EM-53, "Exploded View".
2. Measure ...
Line pressure test
Inspection and Judgment
INSPECTION
Line Pressure Test Port
Line Pressure Test Procedure
1. Inspect the amount of engine oil and replenish if necessary.
2. Drive the car for about 10 minutes to warm it up so that the CVT fluid
reaches in the range of 50 to 80°C
(122 to 176°F), then inspec ...
