Nissan Juke Service and Repair Manual : Engine Control System MR16DDT
- Precaution
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution for Procedure without Cowl Top Cover
- On Board Diagnostic (OBD) System of Engine and CVT
- General Precauti
- Preparation
- System description
- System
- Engine control system
- Direct injection gasoline system
- Fuel pressure control
- Electric ignition system
- Intake valve timing control
- Exhaust valve timing control
- Turbocharger boost control
- Engine protection control at low engine oil pressure
- Air conditioning cut control
- Cooling fan control
- Starter motor drive control
- Evaporative emission system
- Automatic speed control device (ASCD)
- Speed limiter
- NISSAN dynamic control system
- Can communication
- Operation
- Speed limiter
- On board diagnostic (OBD) system
- Diagnosis system (ECM)
- Ecu diagnosis information
- Wiring diagram
- Basic inspection
- Diagnosis and repair workflow
- Basic inspection
- Additional service when replacing ECM
- Accelerator pedal released position learning
- Throttle valve closed position learning
- Idle air volume learning
- G sensor calibration
- Mixture ratio self-learning value clear
- Fuel pressure
- How to set srt code
- DTC/Circuit diagnosis
- Trouble diagnosis - specification value
- Power supply and ground circuit
- U0101 Can comm circuit
- U0122 Vehicle dynamics control module
- U1001 Can comm circuit
- P0011 IVT control
- P0014 EVT control
- P0031, P0032 A/F sensor 1 heater
- P0037, P0038 HO2S2 heater
- P0045, P0047, P0048 TC boost control solenoid valve
- P0075 IVT control solenoid valve
- P0078 EVT control solenoid valve
- P0087, P0088, P0090 FRP control system
- P0097, P0098 IAT sensor 2
- P0102, P0103 MAF sensor
- P0107, P0108 atmospheric pressure sensor
- P0112, P0113 IAT sensor
- P0117, P0118 ECT sensor
- P0122, P0123 TP sensor
- P0130 A/F sensor 1
- P0131 A/F sensor 1
- P0132 A/F sensor 1
- P0133 A/F sensor 1
- P0137 HO2S2
- P0138 HO2S2
- P0139 HO2S2
- P0171 fuel injection system function
- P0172 fuel injection system function
- P0190 FRP sensor
- P0197, P0198 EOT sensor
- P0201, P0202, P0203, P0204 fuel injector
- P0222, P0223 TP sensor
- P0234 TC system
- P0237, P0238 TC boost sensor
- P0300, P0301, P0302, P0303, P0304 misfire
- P0327, P0328 KS
- P0335 CKP sensor (POS)
- P0340 CMP sensor (PHASE)
- P0420 three way catalyst function
- P0444 EVAP canister purge volume control solenoid valve
- P0500 VSS
- P0501, P2159 vehicle speed sensor
- P0506 ISC system
- P0507 ISC system
- P0520 EOP sensor
- P0524 engine oil pressure
- P0603 ECM power supply
- P0605 ECM
- P0607 ECM
- P0611 ECM protection
- P062B ECM
- P0643 sensor power supply
- P0850 PNP switch
- P1078 EVT control position sensor
- P1197 out of gas
- P1212 TCS communication line
- P1217 engine over temperature
- P1220 fuel pump control module (FPCM)
- P1225 TP sensor
- P1226 TP sensor
- P1550 battery current sensor
- P1551, P1552 battery current sensor
- P1553 battery current sensor
- P1554 battery current sensor
- P1556, P1557 battery temperature sensor
- P1564 ASCD steering switch
- P1572 ASCD brake switch
- P1574 ASCD vehicle speed sensor
- P158A ECM
- P159A, P159C, P159D G sensor
- Except for M/T models
- P159B G sensor
- P1650 starter motor relay 2
- P1651 starter motor relay
- P1652 starter motor system COMM
- P1805 brake switch
- P2100, P2103 throttle control motor relay
- P2101 electric throttle control function
- P2118 throttle control motor
- P2119 electric throttle control actuator
- P2122, P2123 APP sensor
- P2127, P2128 APP sensor
- P2135 TP sensor
- P2138 APP sensor
- P2162 vehicle speed sensor
- Fuel injector
- Low pressure fuel pump
- High pressure fuel pump
- Ignition signal
- Electrical load signal
- Cooling fan
- Refrigerant pressure sensor
- Brake pedal position switch
- Clutch pedal position switch
- ASCD main switch
- SPEED LIMITER MAIN SWITCH
- Information display (ASCD)
- Information display (speed limiter)
- Malfunction indicator lamp
- Symptom diagnosis
- Periodic maintenance
- Removal and installation
- Service data and specifications (SDS)
Thermostat
...
Precaution
...
Other materials:
B1068, B1073 passenger air bag module
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
P0643 sensor power supply
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition swit ...
Headlamp (HI) circuit
Component Function Check
1.CHECK HEADLAMP (HI) OPERATION
CONSULT-III ACTIVE TEST
1. Select “EXTERNAL LAMPS” of IPDM E/R active test item.
2. With operating the test items, check that the headlamp (HI) is turned ON.
Hi : Headlamp (HI) ON
Off : Headlamp (HI) OFF
NOTE:
ON/OFF is repeated 1 seco ...
