Nissan Juke Service and Repair Manual : Encoder circuit
Component Function Check
1.CHECK ENCODER OPERATION
Check that front driver side door glass perform AUTO UP/DOWN operation normally when power window main switch is operated.
Is the inspection result normal? YES >> INSPECTION END
NO >> Refer to PWC-30, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK ENCODER PULSE SIGNAL
1. Turn ignition switch ON.
2. Check signal between power window main switch harness connector and ground with oscilloscope.
(): RHD models
Is the inspection result normal? YES >> Replace power window main switch.
NO >> GO TO 2.
2.CHECK ENCODER SIGNAL CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect power window main switch connector and front power window motor (driver side) connector.
3. Check continuity between power window main switch harness connector and front power window motor (driver side) harness connector.
4. Check continuity between power window main switch harness connector and ground.
(): RHD models Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace harness.
3.CHECK ENCODER POWER SUPPLY
1. Connect power window main switch connector.
2. Turn ignition switch ON.
3. Check voltage between front power window motor (driver side) harness connector and ground.
(): RHD models Is the inspection result normal? YES >> GO TO 5.
NO >> GO TO 4.
4.CHECK ENCODER POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect power window main switch connector.
3. Check continuity between power window main switch harness connector and front power window motor (driver side) harness connector.
4. Check continuity between power window main switch harness connector and ground.
(): RHD models Is the inspection result normal? YES >> Replace power window main switch.
NO >> Repair or replace harness.
5.CHECK ENCODER GROUND CIRCUIT 1
1. Turn ignition switch OFF.
2. Disconnect power window main switch connector.
3. Check continuity between power window main switch harness connector and front power window motor (driver side) harness connector.
4. Check continuity between power window main switch harness connector and ground.
(): RHD models
Is the inspection result normal? YES >> GO TO 6.
NO >> Repair or replace harness.
6.CHECK ENCODER GROUND CIRCUIT 2
1. Connect power window main switch connector.
2. Check continuity between power window main switch harness connector and ground.
(): RHD models
Is the inspection result normal? YES >> Replace front power window motor (driver side).
NO >> Replace power window main switch.
Power window motor
DRIVER SIDE
DRIVER SIDE : Component Function Check
1. CHECK FRONT POWER WINDOW MOTOR (DRIVER SIDE) OPERATION
Check front power window motor (driver side) operation with power window main
switch.
...
Other materials:
Front fender
Exploded View
1. Front fender assembly
2. Front fender stiffener
: Vehicle front
Removal and Installation
REMOVAL
1. Remove front fillet molding. Refer to EXT-26, "FRONT FILLET MOLDING :
Removal and Installation".
2. Remove front bumper fascia assembly. Refer to EXT-13, "R ...
A/C auto AMP. Connection recognition signal circuit
Diagnosis Procedure
1.CHECK A/C AUTO AMP. CONNECTION RECOGNITION SIGNAL
1. Turn ignition switch ON.
2. Check voltage between combination meter harness connector and ground.
Is the inspection result normal?
YES >> INSPECTION END
NO >> GO TO 2.
2.CHECK A/C AUTO AMP. CONNECTION R ...
U1010 control unit (CAN)
Description
Initial diagnosis of A/C auto amp.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT-III
1. Turn ignition switch ON.
2. Select “Self Diagnostic Result” mode of “HVAC” using CONSULT-III.
3. Check DTC.
Is DTC detected?
...
