Nissan Juke Service and Repair Manual : EGR volume control valve closed position learning

Description

EGR Volume Control Valve Closed Position Learning is an operation to learn the fully closed position of the EGR volume control valve by monitoring the EGR volume control valve control position sensor output signal.

Work Procedure

1.START

1. Turn ignition switch ON.

2. Perform ???EGR ADAPTIVES??? in WORK SUPPORT mode with CONSULT-III.

3. Turn ignition switch OFF and wait at least 30 seconds.

4. Start engine and let it idle.

5. Select ???DATA MONITOR??? mode with CONSULT-III.

6. Check that the ???NEW EGR/V OFFSET??? and ???LAST EGR/V OFSET??? indication.

0.75V < NEW EGR/V OFFSET = LAST EGR/V OFSET < 1.5V

>> END

    Additional service when replacing ECM
    Description When replacing ECM, this procedure must be performed. Work Procedure 1.PRECONDITIONING • Connect a CONSULT-III • Connect a battery charger • Electric load switch is OFF • Wait for t ...

    Throttle valve closed position learning
    Description Throttle Valve Closed Position Learning is an operation to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be pe ...

    Other materials:

    B2110 shift position/clutch interlock switch
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC B2110 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to PCS- 30, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Shift selector lever to the P position. 2. Turn ign ...

    Headlights
    Fog may temporarily form inside the lens of the exterior lights in the rain or in a car wash. A temperature difference between the inside and the outside of the lens causes the fog. This is not a malfunction. If large drops of water collect inside the lens, contact a NISSAN dealer. Replacing ...

    How to use remote keyless entry function
    WARNING • Radio waves could adversely affect electric medical equipment. Those who use a pacemaker should contact the electric medical equipment manufacturer for the possible influences before use. •  The Intelligent Key transmits radio waves when the buttons are pushed. The FAA advises ...