Nissan Juke Service and Repair Manual : EGR valve

Exploded View

1. EGR valve assembly


1. EGR valve assembly 2. Clamp
3. EGR tube
4. Air inlet tube
5. O-ring
6. Gasket
7. EGR cooler
8. Gasket
9. EGR volume control valve housing 10. Gasket
11. Electric throttle control actuator 12. Gasket
13. EGR volume control valve 14. Clamp
15. Cooling hose

A. To exhaust manifold B. To intake manifold

: Always replace after every: N·m (kg-m, ft-lb)
disassembly.: Always replace after every
disassembly.

Removal and Installation

REMOVAL

1. Drain engine coolant. Refer to CO-62, "Draining".

2. Remove air cleaner case. Refer to EM-280, "Exploded View".

3. Remove cowl top extension. Refer to EXT-20, "Exploded View".

4. Remove turbocharger air inlet pipe. Refer to EM-280, "Exploded View".

5. Remove air inlet tube assembly and air inlet tube. Refer to EM-281, "Exploded View".

6. Remove electric throttle control actuator.

7. Disconnect EGR solenoid valve connector.

8. Remove cooling hose.

9. Remove EGR volume control valve housing mounting bolts.

10. Remove EGR assembly.

INSTALLATION

• Install in the reverse order of removal.

    Charge air cooler
    Exploded View 1. Air inlet hose 2. Clamp 3. Air inlet tube 4. Air inlet hose 5. Charge air cooler 6. Air inlet hose 7. Air inlet tube 8. Turbocharger 9. Air inlet tube assembly A. 1 ...

    Turbocharger
    Exploded View 1. Exhaust manifold 2. Turbocharger 3. Gasket 4. Turbocharger outlet duct 5. Oil outlet hose 6. Clamp 7. Oil return pipe 8. Gasket 9. Washer 10. Oil supply tube 11. O ...

    Other materials:

    Gas station information
    FUEL RECOMMENDATION: NISSAN recommends the use of unleaded premium gasoline with an octane rating of at least 91 AKI (Anti-Knock Index) number (Research octane number 96). If unleaded premium gasoline is not available, you may use unleaded regular gasoline with an octane rating of at least 87 ...

    Power supply and ground circuit
    MULTI DISPLAY UNIT MULTI DISPLAY UNIT : Diagnosis Procedure 1.CHECK FUSES Check if any of the following fuses are blown: Is the check result normal? YES >> GO TO 2. NO >> Replace fuse with a new one after repairing the applicable circuit. 2.CHECK POWER SUPPLY CIRCUIT Check ...

    Diagnosis system (multi display unit)
    CONSULT-III Function APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with multi display unit. SELF DIAGNOSTIC RESULT Refer to AV-111, "DTC Index". DATA MONITOR • *1: MR16DDT • *2: This is not used to determine ON/OFF of the indicator lam ...