Nissan Juke Service and Repair Manual : Ecu diagnosis informatioN
TCM
Reference Value
VALUES ON THE DIAGNOSIS TOOL
*1: Means CVT fluid temperature. Convert numerical values for actual fluid temperature °C (°F). Refer to TM-128, "ATFTEMP COUNT Conversion Table".
TERMINAL LAYOUT
PHYSICAL VALUES
*1: This harness is not used.
*2: A circuit tester cannot be used to test this item.
Fail-safe
The TCM has an electrical fail-safe mode. In this mode TCM is operator even if there is an error in a main electronic control input/output signal circuit.
Description
When a malfunction is detected in each sensor, switch, solenoid or others, this
function provides control to
minimize reduction of drivability so that durability of transmission assembly
can be acquired.
DTC Inspection Priority Chart
If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart.
NOTE
:
If DTC “U1000” is displayed with other DTCs, first perform the trouble diagnosis
for DTC “U1000”.
Refer to TM-195.
DTC Index
NOTE
:
If DTC “U1000” is displayed with other DTCs, first perform the trouble diagnosis
for DTC “U1000”.
Refer to TM-195.
*: These numbers are prescribed by ISO 15031-5.
Diagnosis system (TCM)
CONSULT-III Function (TRANSMISSION) CONSULT-III can display each diagnostic item using the diagnostic test modes shown below. FUNCTION *: “Function Test” can be selected, but do not use it. ...Wiring diagram
...Other materials:
Ring gear shaft
Exploded View
1. Pinion lock nut
2. Companion flange
3. Drive pion oil seal
4. Pinon rear bearing
5. Transfer case
6. Gasket
7. Filler plug
8. Collapsible spacer
9. Drive pinion adjust shim
10. Drive pinion
11. Pinion front bearing
12. Ring gear
13. Ring gear shaft
14. Ring ...
List of voice commands
When you push and release the button
on the steering wheel, you can choose from the commands on the Main Menu. The following
pages describe these commands and the commands in each sub-menu.
Remember to wait for the tone before speaking. You can say “Help” to hear
the list of commands curre ...
Overspeed at idle speed or on releasing brake
Description
CHART 14: OVERSPEED AT IDLE SPEED OR ON RELEASING BRAKE
Diagnosis Procedure
1.CHECK ENGINE OIL
Check the grade of engine oil. Refer to LU-33, "Inspection".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Replace engine oil. Refer to LU-34, "Re ...