Nissan Juke Service and Repair Manual : ECM
Removal and Installation
REMOVAL
1. Remove fusible link bracket. Keep a service area.
2. Disconnect ECM harness connectors. Refer to PG-4, "Harness Connector".
3. Remove ECM mounting nuts,and then remove ECM.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
Must be perform additional service when replacing ECM. Refer to EC-541, "Work
Procedure".
Fuel pump control module (FPCM)
Removal and Installation REMOVAL 1. Remove Luggage side lower finisher LH. Refer to INT-31, "LUGGAGE SIDE LOWER FINISHER : Removal and Installation". 2. Disconnect fuel pump control mo ...Other materials:
Wheel sensor
Front wheel sensor : Exploded View
1. Front LH wheel sensor
2. Front LH wheel sensor harness connector
: Vehicle front
: N·m (kg-m, in-lb)
NOTE:
Front RH wheel sensor is symmetrically opposite of LH.
Front wheel sensor : Removal and Installation
REMOVAL
1. Remove tires.
2. Remove the fe ...
Headlamp washer circuit
Component Function Check
1.CHECK HEADLAMP WASHER OPERATION
CONSULT-III ACTIVE TEST
1. Select “HEAD LAMP WASHER” of IPDM E/R active test item.
2. With operating the test item, check headlamp operation.
On :Headlamp washer ON operation
Off :Stop the headlamp washer.
Is headlamp washer operation ...
A/C switch
Component Function Check
1.CHECK A/C ON SIGNAL
With CONSULT-III
1. Turn ignition switch ON.
2. Select “AIR CONDITIONER” of “BCM” using CONSULT-III.
3. Select “AIR COND SW” in “DATA MONITOR” mode, and check status under the
following condition.
Is the inspection result normal?
YES >> ...