Nissan Juke Service and Repair Manual : ECM

Removal and Installation

REMOVAL

1. Remove fusible link bracket. Keep a service area.

2. Disconnect ECM harness connectors. Refer to PG-4, "Harness Connector".

3. Remove ECM mounting nuts, and then remove ECM.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
Must be perform additional service when replacing ECM. Refer toEC-133, "Work Procedure".

    Fuel pump control modul (FPCM)
    Removal and Installation REMOVAL 1. Remove Luggage side lower finisher LH. Refer to INT-31, "LUGGAGE SIDE LOWER FINISHER : Removal and Installation". 2. Disconnect fuel pump control mo ...

    Other materials:

    Engine coolant
    Inspection LEVEL • Check that the reservoir tank engine coolant level is within the “MIN” to “MAX” when the engine is cool. A : MAX B : MIN • Adjust the engine coolant level if necessary. LEAKAGE • To check for leakage, apply pressure to the cooling system with the radiator cap tester (co ...

    System
    POWER WINDOW SYSTEM POWER WINDOW SYSTEM : System Diagram POWER WINDOW SYSTEM : System Description • Power window system is activated by power window switch when ignition switch turns ON. • Power window main switch opens/closes all door glass. • Front and rear power window switch opens/close ...

    P1553 battery current sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. ...