Nissan Juke Service and Repair Manual : DTC Index
*1: 1st trip DTC No. is the same as DTC No.
*2: This number is prescribed by SAE J1979/ ISO 15031-5.
*3: In Diagnostic Test Mode II (Self-diagnostic results), this number is controlled by NISSAN.
*4: The troubleshooting for this DTC needs CONSULT-III.
*5: When the fail-safe operations for both self-diagnoses occur, the MIL illuminates.
*6: This self-diagnosis is not for ECM power supply circuit, even though “ECM BACK UP/CIRCUIT” is displayed on CONSULT-III screen.
DTC Inspection Priority Chart
If some DTCs are displayed at the same time, perform inspections one by one
based on the following priority
chart.
NOTE:
*: If “P1197” is displayed with other DTC in priority 1, perform trouble ...
Test Value and Test Limit
The following is the information specified in Service $06 of ISO 15031-5.
The test value is a parameter used to determine whether a system/circuit
diagnostic test is OK or NG while
being monitor ...
Other materials:
Service Notice or Precaution
OBD SELF-DIAGNOSIS (WITH OBD)
• CVT self-diagnosis is performed by the TCM in combination with the ECM. The
results can be read through
the blinking pattern of the malfunction indicator (MI). Refer to the table on
TM-159, "CONSULT-III Function
(TRANSMISSION)" for the indicator used ...
Before starting the engine
• Make sure the area around the vehicle is clear.
• Check fluid levels such as engine oil, coolant, brake fluid, and window washer
fluid as frequently as
possible, or at least whenever you refuel.
• Check that all windows and lights are clean.
• Visually inspect tires for their appearance and ...
Component parts
Component Parts Location
1. Intelligent Key warning buzzer
2. Remote keyless entry receiver
3. Inside key antenna (instrument center)
4. TCM
Refer to TM-133, "CVT CONTROL
SYSTEM : TCM" (RE0F10B models)
or TM-316, "CVT CONTROL SYSTEM
: TCM" (RE0F11A models)
5. Push-bu ...
