Power generation voltage variable control system operation inspection

Inspection Procedure CAUTION: When performing this inspection, always use a charged battery that has completed the battery inspection. (When the charging rate of the battery is low, the respons ...

B terminal circuit

Description “B” terminal circuit supplies power to charge the battery and to operate the vehicle’s electrical system. Diagnosis Procedure 1.CHECK “B” TERMINAL CONNECTION 1. Turn ignition switch ...

Other materials:

Evaporative emission system
Inspection 1. Visually inspect EVAP vapor lines for improper attachment and for cracks, damage, loose connections, chafing and deterioration. 2. Check EVAP canister as follows: a. Block port (A). Orally blow air through port (B). Check that air flows freely through port (C). b. Block port (B ...

P0725 engine speed
Description The engine speed signal is transmitted from ECM to TCM by CAN communication line. DTC Logic DTC DETECTION LOGI DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition ...

Position switch
Removal and Installation REMOVAL 1. Remove air cleaner case. (K9K) Refer to EM-280, "Removal and Installation". 2. Remove battery. (MR16DDT) Refer to PG-124, "Removal and Installation". 3. Disconnect position switch connector. 4. Remove position switch from transaxle case. ...