Nissan Juke Service and Repair Manual : DTC/circuit diagnosis
- Front wiper motor lo circuit
- Front wiper motor hi circuit
- Front wiper auto stop signal circuit
- Front wiper motor ground circuit
- Light & rain sensor
- Washer switch
- Rear wiper motor circuit
- Rear wiper auto stop signal circuit
- Headlamp washer relay
- Headlamp washer circuit
- Wiper and washer system
- Headlamp washer system
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1.INTERVIEW FOR MALFUNCTION Interview the symptom to the customer. >> GO TO 2. 2.SYMPTOM CHECK Check the sympto ...Front wiper motor lo circuit
Component Function Check 1.CHECK FRONT WIPER LO OPERATION CONSULT-III ACTIVE TEST 1. Select “FRONT WIPER” of IPDM E/R active test item. 2. With operating the test item, check front wiper operation ...Other materials:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and front passenger for certain
types of collision. Information necessary to service the system safely is
include ...
Diagnosis system (BCM)
Common item
COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the fo ...
B1130 side air bag module RH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...