Check anti-pinch function

Description If any of the following operations are performed, the initialization is necessary for normal operation of antipinch function. • Disconnection and connection of battery cable from ne ...

Power supply and ground circuit

Power window main switch POWER WINDOW MAIN SWITCH : Diagnosis Procedure 1.CHECK POWER WINDOW MAIN SWITCH POWER SUPPLY 1. Turn ignition OFF. 2. Disconnect power window main switch connector. 3. Ch ...

Other materials:

P1840 output speed signal
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

Combination switch
Exploded View 1. Combination switch 2. Combination switch connector Removal and Installation REMOVAL 1. Remove steering column cover. Refer to IP-13, "Removal and Installation". 2. Remove screws. 3. Disconnect the connector. 4. Pull up the combination switch to remove it. I ...

Precaution for Brake System
WARNING: Clean any dust from the front brake and rear brake with a vacuum dust collector. Never blow with compressed air. • Brake fluid use refer to MA-13, "Fluids and Lubricants". • Never reuse drained brake fluid. • Never spill or splash brake fluid on painted surfaces. Brake flui ...