Nissan Juke Service and Repair Manual : DTC/circuit diagnosis
- Back door opener actuator
- Back door opener switch
- Door lock actuator
- Door lock and unlock switch
- Door switch
- Hazard function
- Key switch
- Keyfob battery
- Remote keyless entry receiver
- Unlock sensor
Keyfob ID registration
Description Perform the following procedure after BCM is replaced or when new keyfob ID is registered NOTE: When registering the keyfob ID, perform only one procedure to simultaneously register ...Back door opener actuator
Diagnosis Procedure 1.CHECK BACK DOOR OPENER ACTUATOR INPUT SIGNAL 1. Turn ignition switch OFF. 2. Disconnect back door opener assembly connector. 3. Check voltage between back door opener assembl ...Other materials:
Outside mirrors
WARNING
Objects viewed in the outside mirror on the passenger side are closer than
they appear. Be careful when moving to the right. Using only this mirror could cause
an accident. Use the inside mirror or glance over your shoulder to properly judge
distances to other objects.
Adjusting ou ...
Door motor
Exploded View
LEFT SIDE
1. A/C unit assembly
2. Intake door lever
3. Intake door link
4. Intake door motor
5. Air mix door motor
6. Air mix door link
7. Max. cool door
8. Upper air mix door lever
9. Air mix door rod
10. Lower air mix door lever
RIGHT SIDE
1. A/C unit assembly ...
P1551, P1552 battery current sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following before conducting
the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. ...