Nissan Juke Service and Repair Manual : DTC/circuit diagnosis
- C1601 battery power supply
- C1604 torque sensor
- C1606 EPS motor
- C1607, C1608 EPS control unit
- C1609 vehicle speed signal
- U1000 can comm circuit
- EPS warning lamp
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW Work Flow DETAILED FLOW 1.INTERVIEW FROM THE CUSTOMER Clarify customer complaints before inspection. First of all, perform an interview utilizing STC-17, "Diag ...C1601 battery power supply
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 ...Other materials:
P060A ECM
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.INSPECTION START
1. Turn ignition switch ON.
2. Erase DTC.
3. Turn ignition switch OFF and wait for 20 seconds.
4. Turn ignition switch ON and perform the self-diagnosis.
Is the DTC P060A displayed again?
YES >> GO TO 2.
NO &g ...
RHD
RHD : Wiring Diagram
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation
of Option Abbreviation".
...
Washer switch
Component Inspection
1.CHECK WASHER SWITCH
1. Turn ignition switch OFF.
2. Disconnect combination switch connector.
3. Check continuity between the combination switch terminals.
A : Terminal 4
B : Terminal 6
C : Terminal 3
D : Terminal 1
Is the inspection result normal?
YES >> IN ...