Nissan Juke Service and Repair Manual : DTC/circuit diagnosis
- C1101, C1102, C1103, C1104 wheel sensor
- C1105, C1106, C1107, C1108 wheel sensor
- C1109 power and ground system
- C1110, C1170 ABS actuator and electric unit (control unit)
- C1111 ABS motor, motor relay system
- C1113, C1145, C1146 yaw rate/side/decel g sensor
- C1115 wheel sensor
- C1116 stop lamp switch
- C1120, C1122, C1124, C1126 ABS in valve system
- C1121, C1123, C1125, C1127 ABS out valve system
- C1130 engine signal
- C1140 actuator relay system
- C1142 press sensor
- C1143 steering angle sensor
- C1144 incomplete steering angle sensor adjustment
- C1155 brake fluid level switch
- C1164, C1165 CV system
- C1166, C1167 SV system
- C1176 stop lamp SW2
- U1000 can comm circuit
- U1010 control unit (can)
- Power supply and ground circuit
- Parking brake switch
- ESP off switch
- ABS warning lamp
- Brake warning lamp
- ESP warning lamp
- ESP off indicator lamp
Adjustment of steering angle sensor neutral position
Description Always adjust the neutral position of steering angle sensor before driving when the following operation is performed. Work Procedure ADJUST THE NEUTRAL POSITION OF STEERING ANGLE SE ...C1101, C1102, C1103, C1104 wheel sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 ...Other materials:
Back door lock
Exploded View
1. Back door lock assembly
2. TORX bolt
3. Back door striker
: Do not reuse
: N·m (kg-m, ft-lb)
: Body grease
Door lock
DOOR LOCK : Removal and Installation
REMOVAL
1. Remove the back door lower finisher. Refer to INT-35, "BACK DOOR LOWER
FINISHER : Removal and
Ins ...
Air conditioner filter
Exploded View
LHD models
1. A/C unit assembly
2. Air conditioner filter
3. Filter cover
Removal and Installation (LHD models)
REMOVAL
1. Remove glove box assembly. Refer to IP-13, "Removal and Installation".
2. Remove filter cover (1), and then remove air conditioner filter (2) ...
Locking with power door lock switch
Driver’s armrest
Operating the power door lock switch will lock or unlock all the doors. The switch
is located on the driver’s door armrest.
To lock the doors, push the power door lock switch to the lock position 1 with
the driver’s door open, then close the door.
When locking the door this ...