Nissan Juke Service and Repair Manual : DTC/CIRCUIT DIAGNOSIS
- U0073 communication bus A off
- U0100 lost communication (ECM A)
- U0140 lost communication (BCM)
- U0141 lost communication (BCM A)
- U0155 lost communication (IPC)
- U0300 can communication data
- U1000 can comm circuit
- U1117 lost communication (ABS)
- U1119 lost comm (multi-display)
- P062f eeprom
- P0705 transmission range switch A
- P0706 transmission range sensor A
- P0711 transmission fluid temperature sensor A
- P0712 transmission fluid temperature sensor A
- P0713 transmission fluid temperature sensor A
- P0715 input speed sensor A
- P0720 output speed sensor
- P0740 torque converter
- P0743 torque converter
- P0744 torque converter
- P0746 pressure control solenoid A
- P0846 transmission fluid pressure SEN/SW B
- P0847 transmission fluid pressure SEN/SW B
- P0848 transmission fluid pressure SEN/SW B
- P0863 TCM communication
- P0962 pressure control solenoid A
- P0963 pressure control solenoid A
- P1586 G sensor
- P1588 G sensor
- P1701 TCM
- P1739 1GR incorrect ratio
- P173A 2GR incorrect ratio
- P173B 1GR incorrect ratio
- P173C 2GR incorrect ratio
- P17B4 low brake solenoid
- P17B5 low brake solenoid
- Component Inspection (Low Brake Solenoid Valve)
- P17B7 high clutch solenoid
- P17B8 high clutch solenoid
- P17Ba primary pressure solenoid
- P17BB primary pressure solenoid
- P2765 clutch B speed sensor
- Main power supply and ground circuit
- S mode switch
- S mode indicator
- Shift position indicator circuit
- Shift lock system
CVT position
Inspection and Adjustment INSPECTION 1. Turn ON the ignition switch with the selector lever at the P position. 2. Press the selector button with the brake pedal depressed, and confirm that the le ...U0073 communication bus A off
Description CAN (Controller Area Network) is a serial communication line for real-time application. It is an on-vehicle multiplex communication line with high data communication speed and excellen ...Other materials:
Front fender
Exploded View
1. Front fender assembly
2. Front fender stiffener
: Vehicle fr
Removal and Installation
REMOVAL
1. Remove front fillet molding. Refer to EXT-26, "FRONT FILLET MOLDING :
Removal and Installation".
2. Remove front bumper fascia assembly. Refer to EXT-13, "Remo ...
MR16DDT : Inspection and Adjustment
INSPECTION
Magnetic Switch Check
• Before starting to check, disconnect the battery cable from the negative
terminal.
• Disconnect “M” terminal of starter motor.
1. Continuity test [between “S” terminal (A) and switch body]
B : “B” terminal
C : “M” terminal
• Replace magnetic switch if co ...
Component parts
Component Parts Location
1. Front door speaker LH
2. Rear door speaker LH
3. Rear view camera
4. Rear door speaker RH
5. Antenna rod
6. Antenna base (antenna amp.)
7. Front door speaker RH
8. Microphone
9. GPS antenna
10. Tweeter LH
11. Steering switch
12. USB connector and AUX ...