Nissan Juke Service and Repair Manual : DTC/Circuit diagnosis
POSITION SWITCH
BACK-UP LAMP SWITCH : Component Inspection
1.CHECK BACK-UP LAMP SWITCH
1. Disconnect position switch connector. Refer to TM-24, "Removal and Installation".
2. Check continuity between position switch terminals.
Is the inspection result normal? YES >> INSPECTION END
NO >> Replace position switch. Refer to TM-24, "Removal and Installation".
PARK/NEUTRAL POSITION (PNP) SWITCH : Component Inspection
1.CHECK PARK/NEUTRAL POSITION (PNP) SWITCH
1. Disconnect position switch connector. Refer to TM-24, "Removal and Installation".
2. Check continuity between position switch terminals.
Is the inspection result normal? YES >> INSPECTION END
NO >> Replace position switch. Refer to TM-24, "Removal and Installation".
Structure and operation
Sectional View 1. 5th input gear 2. 5th-reverse synchronizer hub assembly 3. Input shaft 4. Mainshaft 5. 5th main gear 6. Mainshaft rear bearing 7. 4th main gear 8. 3rd-4th synchronizer ...Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. The numbers indicate the order of the inspection. If necessary, ...Other materials:
Power transistor
Exploded View
1. A/C unit assembly
2. Blower fan resistor*1
3. Sub harness*1
4. Power transistor*2
5. Sub harness*2
6. Blower motor
• *1: Manual air conditioner
• *2: Automatic air conditioner
Removal and Installation
REMOVAL
1. Remove instrument panel assembly. Refer to IP-13, &quo ...
ECU diagnosis information
ABS actuator and electric unit (control unit)
Reference Value
CONSULT-III DATA MONITOR STANDARD VALUE
*1: Confirm tire pressure is standard value.
*2: Refer to “valve operation” in BRC-105, "System Description" for valve
operation of each valve.
*3: Refer to BRC-105, "Sys ...
C1140 actuator relay system
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...