Nissan Juke Service and Repair Manual : DTC/Circuit diagnosis
- P1804, P1809 4WD control module
- P1808 Wheel speed sensor
- P1811 power supply circuit for 4wd control module
- P1813 4WD mode switch
- P181B incomplete selfshut
- P181D engine torque signal
- P181E steering angle sensor
- P181F incomplete calibration
- P1820 engine speed signal
- P1829 accelerator pedal position sensor
- P182D 4WD solenoid left
- P182E 4WD solenoid right
- P182F coupling temperature sensor left
- P1830 ABS operation signal
- P1831 VDC operation signal
- P1832 TCS operation signal
- P183A coupling temperature sensor right
- P183B solenoid power supply
- P183C decel G sensor
- P183D side G sensor
- P183E yaw rate sensor
- P183F gear position signal
- P1840 output speed signal
- P1864 input speed signal
- P1865 gear ratio signal
- U1000 can comm circuit
- U1010 control unit (CAN)
- Power supply and ground circuit
- 4WD warning lamp
- 4WD mode indicator lamp (4WD-V)
- 4WD mode indicator lamp (4WD)
Writing unit parameter
Description Perform writing unit parameter of electric controlled coupling after replacing 4WD control module, rear final drive assembly or electric controlled coupling. Refer to DLN-39, "Wor ...P1804, P1809 4WD control module
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 ...Other materials:
System
System Description
• The system switches fluid pressure of each brake caliper to increase, to
hold or to decrease according to
signals from control unit in ABS actuator and electric unit (control unit). This
control system is applied to ABS
function and EBD function.
• Fail-safe function is ...
P047B exhaust gas pressure sensor 2
DTC Logic
DTC DETECTION LOGIC
Diagnosis Proce
1.CHECK GROUND CONNECTIONS
1. Turn ignition switch OFF and wait at least 20 seconds.
2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit
Inspection".
Is the inspection result normal?
YES >> GO TO 2.
...
Rear shock absorber
Exploded View
1. Suspension arm
2. Shock absorber
3. Bound bumper
4. Bound bumper cover
5. Washer
6. Bushing
7. Distance tube
8. Piston rod lock nut
9. Cap
: Vehicle front
: Always replace after every
disassembly.
: N·m (kg-m, ft-lb)
Removal and Installation
REMOVAL
1. Remove ...