Nissan Juke Owners Manual : Driving on snow or ice

WARNING

• Wet ice (328F, 08C and freezing rain), very cold snow or ice can be slick and very hard to drive on. The vehicle will have much less traction or “grip” under these conditions. Try to avoid driving on wet ice until the road is salted or sanded.

• Whatever the condition, drive with caution. Accelerate and slow down with care. If accelerating or downshifting too fast, the drive wheels will lose even more traction.

• Allow more stopping distance under these conditions. Braking should be started sooner than on dry pavement.

• Allow greater following distances on slippery roads.

• Watch for slippery spots (glare ice).

These may appear on an otherwise clear road in shaded areas. If a patch of ice is seen ahead, brake before reaching it. Try not to brake while on the ice, and avoid any sudden steering maneuvers.

• Do not use cruise control on slippery roads.

• Snow can trap dangerous exhaust gases under your vehicle. Keep snow clear of the exhaust pipe and from around your vehicle.

    Special winter equipment
    It is recommended that the following items be carried in the vehicle during winter: •  A scraper and stiff-bristled brush to remove ice and snow from the windows and wiper blades. • A sturdy, ...

    Engine block heater (if so equipped)
    Engine block heaters are used to assist in cold temperature starting. The engine block heater should be used when the outside temperature is 208F (−78C) or lower. To use the engine block hea ...

    Other materials:

    Charge air cooler
    Exploded View 1. Air inlet hose 2. Clamp 3. Air inlet tube 4. Air inlet hose 5. Charge air cooler 6. Air inlet hose 7. Air inlet tube 8. Turbocharger 9. Air inlet tube assembly A. 1st step: 5.0 N·m (0.51 kg-m, 44 ft-lb) 2nd step: 7.0 N·m (0.71 kg-m, 62 ftlb) B. Paint mark C. T ...

    Back door opener switch
    Component Function Check 1.CHECK FUNCTION 1. Select “TRUNK” of “BCM” using CONSULT-III. 2. Select “TRNK OPNR SW” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Back door opener switch ...

    Main line between ipdm-e and dlc circuit
    Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side). - Harness connector E105 - Harness co ...