Nissan Juke Service and Repair Manual : Driveline transfer: TY21B
- Precaution
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
- Service Notice or Precautions for Transfer
- Preparation
- System description
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- DTC/Circuit diagnosis
- P1804, P1809 4WD control module
- P1808 Wheel speed sensor
- P1811 power supply circuit for 4wd control module
- P1813 4WD mode switch
- P181B incomplete selfshut
- P181D engine torque signal
- P181E steering angle sensor
- P181F incomplete calibration
- P1820 engine speed signal
- P1829 accelerator pedal position sensor
- P182D 4WD solenoid left
- P182E 4WD solenoid right
- P182F coupling temperature sensor left
- P1830 ABS operation signal
- P1831 VDC operation signal
- P1832 TCS operation signal
- P183A coupling temperature sensor right
- P183B solenoid power supply
- P183C decel G sensor
- P183D side G sensor
- P183E yaw rate sensor
- P183F gear position signal
- P1840 output speed signal
- P1864 input speed signal
- P1865 gear ratio signal
- U1000 can comm circuit
- U1010 control unit (CAN)
- Power supply and ground circuit
- 4WD warning lamp
- 4WD mode indicator lamp (4WD-V)
- 4WD mode indicator lamp (4WD)
- Symptom diagnosis
- 4WD warning lamp does not turn on
- 4WD warning lamp does not turn off
- Heavy tight-corner braking symptom occurs
- Vehicle does not enter 4WD mode
- 4WD warning lamp blinks quickly
- 4WD warning lamp blinks slowly
- Noise, vibration and harshness (NVH) troubleshooting
- Periodic maintenance
- Removal and installation
- Unit removal and installation
- Unit disassembly and assembly
- Service data and specifications
Clutch Cover
...Precaution
...Other materials:
Back door opener actuator
Component Function Check
1.CHECK FUNCTION
1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.
2. Select “TRUNK/BACK DOOR” in “ACTIVE TEST” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Back door o ...
Draining
1. Start engine and let it run to warm up transaxle.
2. Stop engine. Remove drain plug (1) and gasket, using a socket
[Commercial service tool] and then drain gear oil.
3. Set a gasket on drain plug and install it to clutch housing, using
a socket [Commercial service tool].
CAUTION:
Never re ...
Door does not lock/unlock with door request switch
All door request switches
ALL DOOR REQUEST SWITCHES : Description
All doors do not lock/unlock using all door request switches.
ALL DOOR REQUEST SWITCHES : Diagnosis Procedure
1.CHECK REMOTE KEYLESS ENTRY FUNCTION
Check remote keyless entry function.
Does door lock/unlock with Intelligent Ke ...