Nissan Juke Service and Repair Manual : Drive belt
Checking Drive Belts
WARNING:
Be sure to perform when the engine is stopped.
1. Inspect belts for cracks, fraying, wear and oil. If necessary, replace.
2. Evaluate manually if the belt is enough tensioned (tension cannot be measured by way of frequency meter).
CAUTION:
Auto-tensioner must be replaced with a new one when the
belt is replaced.
Tension Adjustment
Belt tensioning is not necessary, as it is automatically adjusted by auto-tensioner.
Removal and Installation
CAUTION: • Replace any belt that has been removed with a new one.
• Auto-tensioner must be replaced with new ones when the belt is replaced.
• Never run the engine without the drive belts to avoid damaging the crankshaft pulley
.
REMOVAL
1. Remove engine undercover.
2. Remove RH front wheel.
3. Remove fender protector RH. Refer to EXT-22, "Exploded View".
4. Remove drive belt.
• Turn clockwise adjusting bolt.
5. If necessary, remove auto-tensioner.
INSTALLATION
1. Install auto-tensioner mounting bolt.
Auto-tensioner mounting bolt : 40 N·m (4.1 kg-m, 30 ft-lb)
• Align the notch and tighten mounting bolt.
2. Install the drive belt.
CAUTION:
• Make sure belt is correctly engaged with the pulley
groove.
• Check for oil and coolant on belt and each pulley groove.
• Certain drive belts have five teeth whereas the air conditioning compressor pulley, power-assisted steering pump pulley, and alternator pulley all have six teeth.In this case, it is essential to check that inner tooth (O) of the pulleys remains free when fitting the drive belt.
Never turn the engine in the opposite direction to its normal operating direction.
Use a brush to remove any deposits from the crankshaft pulley V grooves.
For engines fitted with a mechanical tensioning roller, it is essential to replace the tensioning roller mounting bolts.
3. Make sure that tension of each belt is within the standard.
Air cleaner filter
Exploded View 1. Turbocharger air inlet pipe 2. Clamp 3. Air duct (suction) 4. Air mass flow sensor 5. O-ring 6. Air duct (inlet) 7. Grommet 8. Air cleaner case 9. Air cleaner filter ...Other materials:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and front passenger for certain
types of collision. Information necessary to service the system safely is
include ...
Rear wheel hub and housing
Exploded View
1. Axle housing
2. Suspension arm
3. Back plate
4. Hub bolt
5. Wheel hub assembly (Bearing-integrated
type)
6. Disc rotor
7. Plug
8. Wheel hub lock nut
9. Cotter pin
: Always replace after every
disassembly.
: N·m (kg-m, ft-lb)
Removal and Ins
REMOVAL
1. Remove ...
Rear window defogger on signal
With auto A/C
WITH AUTO A/C : Description
Turns the indicator lamp in the rear window defogger switch ON when operating
the rear window defogger
WITH AUTO A/C : Component Function Check
1.CHECK REAR WINDOW DEFOGGER ON SIGNAL
Check that the indicator lamp of rear window defogger switch is illu ...