Nissan Juke Service and Repair Manual : Door outside molding
Exploded View
1. Front door panel
2. Front door outside molding
3. Rear door panel
4. Rear door outside molding
5. Door glass
: Pawl
Front door outside molding
FRONT DOOR OUTSIDE MOLDING : Removal and Installation
REMOVAL
1. Fully open front door glass.
2. Twist door outside molding toward the outside of the vehicle, and then lift up and remove it while disengaging the pawls.
INSTALLATION
Note the following item, and then install in the reverse order of removal.
CAUTION
:
When installing front door outside molding, check that pawl (1)
is accurately aligned with mounting hole (2), then press in.
Rear door outside molding
REAR DOOR OUTSIDE MOLDING : Removal and Installation
REMOVAL
1. Fully open rear door glass.
2. Twist rear door outside molding toward vehicle outside and remove molding while disengaging it from door panel.
: Pawl
3. Slide rear door outside molding (1) toward vehicle front, and then pull molding out from rear door handle (2).
INSTALLATION
Note the following item, and then install in the reverse order of removal.
CAUTION:
When installing rear door outside molding, check that pawl (1)
is accurately aligned with mounting hole (2), then press in.
Roof side molding
Exploded View 1. Roof side molding 2. Roof side molding clip 3. Double-sided tape [t: 2.5 mm (0.098 in)] 4. Body side outer panel 5. Roof panel : Vehicle front : Do not reuse Removal and ...Door sash tape
Exploded View 1. Front door panel 2. Front door sash tape 3. Rear door sash tape 4. Rear door panel : Do not reuse Front door sash tape FRONT DOOR SASH TAPE : Removal and Installation REMO ...Other materials:
Fuel level sensor unit
Exploded View
1. Lock ring
2. Fuel level sensor unit
3. Seal packing
A. To fuel tank
: Always replace after every
disassembly
Removal and Installation
WARNING:
Read “General Precautions” when working on the fuel system. Refer to FL-45,
"General Precautions".
REMOVAL
1. Ch ...
Inspection
OIL LEAKAGE
Check rear final drive surrounding area (oil seal, drain plug, filler plug,
and carrier case, etc.) for oil leakage.
OIL LEVEL
1. Remove filler plug (1) and check oil level from filler plug mounting
hole as shown in the figure.
CAUTION:
Never start engine while checking oil l ...
System
Warning chime system
WARNING CHIME SYSTEM : System Diagram
WARNING CHIME SYSTEM : System Description
COMBINATION METER
The combination meter sounds the alarm buzzer installed in the combination
meter when receiving the buzzer
output signal transmitted from each unit.
BCM
BCM receives si ...