Nissan Juke Service and Repair Manual : Door & Lock type 4
- How to use this manual
- Precaution
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution Necessary for Steering Wheel Rotation after Battery Disconne
- Precaution for Procedure without Cowl Top Cover
- Work
- Preparation
- System description
- Component parts
- Power door lock system
- Remote keyless entry system
- Back door opener system
- Diagnosis system (BCM)
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosis
- Back door opener actuator
- Back door opener switch
- Door lock actuator
- Door lock and unlock switch
- Door switch
- Hazard function
- Key switch
- Keyfob battery
- Remote keyless entry receiver
- Unlock sensor
- Symptom diagnosis
- Door does not lock/unlock with door lock and unlock switch
- Door does not lock/unlock with driver side door lock knob or door key cylinder
- Door does not lock/unlock with keyfob
- Back door does not opened
- ANTI-HIJACK function does not operate
- Vehicle speed sensing auto lock operation does not operate
- IGN off interlock door unlock function does not operate
- P range interlock door lock/unlock function does not operate
- Auto door lock operation does not operate
- Unlock link function does not operate
- Key out interlock door unlock function does not operate
- Key reminder function does not operate
- Hazard reminder operation does not operate
- Squeak and rattle trouble diagnoses
- Removal and installation
Keyfob battery
Exploded View 1. Upper case 2. Key 3. Switch cover 4. Switch rubber 5. Board surface 6. Battery 7. plate 8. Lower case 9. Screw Removal and Installation REMOVAL 1. Remove screw (9) ...How to use this manual
APPLICATION NOTICE Information Check the vehicle type to use the service information in this section. ...Other materials:
Front fog lamp circuit
Component Function Check
1.CHECK FRONT FOG LAMP OPERATION
CONSULT-III ACTIVE TEST
1. Select “EXTERNAL LAMPS” of IPDM E/R active test item.
2. With operating the test items, check that the front fog lamp is turned ON.
Fog : Front fog lamp ON
Off : Front fog lamp OFF
Is the measurement normal?
...
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1.INTERVIEW FOR MALFUNCTION
Interview the symptom to the customer.
>> GO TO 2.
2.SYMPTOM CHECK
Check the symptom from the customer's information.
>> GO TO 3.
3.BASIC INSPECTION
Check the operation o ...
B1113, B1114 satellite sensor RH
DTC Logic
DTC DETECTION LOGIC
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp status. Refer to SRC-12, "On ...