Nissan Juke Service and Repair Manual : Door & Lock type 3
- How to use this manual
- Precaution
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
- Precaution for Procedure without Cowl Top Cover
- Work
- Preparation
- System description
- Component parts
- Power door lock system
- Remote keyless entry system
- Back door opener system
- Diagnosis system (BCM)
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosis
- Back door opener actuator
- Back door opener switch
- Door lock actuator
- Door lock and unlock switch
- Door lock status indicator
- Door switch
- Hazard function
- Key switch
- Keyfob battery
- Remote keyless entry receiver
- Super lock actuator
- Unlock sensor
- Symptom diagnosis
- Door does not lock/unlock with door key cylinder operation
- Door does not lock/unlock with door lock and unlock switch
- Door does not lock/unlock with keyfob
- Door lock status indicator does not illuminate
- Super lock does not operatE
- Back door does not opened
- ANTI-HIJACK function does not operate
- Vehicle speed sensing auto lock operation does not operate
- IGN off interlock door unlock function does not operate
- P range interlock door lock/unlock function does not operate
- Auto door lock operation does not operate
- Door lock status indicator does not illuminate
- Unlock link function does not operate
- Key out interlock door unlock function does not operate
- Key reminder function does not operate
- Hazard reminder operation does not operate
- Squeak and rattle trouble diagnoses
- Removal and installation
Intelligent key battery
Removal and Installation 1. Release the lock knob at the back of the Intelligent Key and remove the mechanical key. 2. Insert a flat-blade screwdriver (A) wrapped with a cloth into the slit of th ...How to use this manual
APPLICATION NOTICE Information Check the vehicle type to use the service information in this section. ...Other materials:
P0102, P0103 MAF sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition swit ...
Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
DETAILED FLOW
1.OBTAIN INFORMATION ABOUT SYMPTOM
Interview the customer to obtain as much malfunction information (conditions
and environment when the malfunction
occurred) as possible when the customer brings the vehicle in.
>> GO TO 2.
2. ...
Periodic maintenance
REAR PROPELLER SHAFT
Inspection
APPEARANCE AND NOISE
• Check the propeller shaft tube surface for dents or cracks. If damaged,
replace propeller shaft assembly.
• If center bearing is noisy or damaged, replace propeller shaft assembly.
VIBRATION
If vibration is present at high speed, inspe ...