Nissan Juke Service and Repair Manual : Does not operate
Description
ABS function and EBD function does not operate.
Diagnosis Procedure
CAUTION:
ABS function and EBD function never operate when the vehicle speed is 10 km/h
(6.2 MPH) or les
s.
1.CHECK ABS WARNING LAMP
Check that ABS warning lamp and brake warning lamp turn ON and turn OFF approx. 1 second after key switch is turned ON. Check that ABS warning lamp and brake warning lamp and stay in OFF status during driving.
CAUTION:
Brake warning lamp turns ON when parking brake is operated (parking brake switch
is ON) or brake
fluid is less than the specified level (brake fluid level switch is ON).
Is the inspection result normal? YES >> Normal
NO >> Perform self-diagnosis for “ABS” with CONSULT-III.
The braking distance is long
Description Brake stopping distance is long when ABS function is operated. Diagnosis Procedure CAUTION: Brake stopping distance on slippery road like rough road, gravel road or snowy road may be ...Brake pedal vibration or operation sound occurs
Description • Brake pedal vibrates and motor sound from ABS actuator and electric unit (control unit) occurs, when the engine starts. • Brake pedal vibrates during braking. CAUTION: Vibration ...Other materials:
Component parts
Body control system
BODY CONTROL SYSTEM : Component Parts Locatio
RHD MODELS
1. BCM
A. Behind of glove box (Left side)
LHD MODELS
1. BCM
A. Behind of instrument lower panel LH
(Left side)
Power consumption control system
POWER CONSUMPTION CONTROL SYSTEM : Component Parts Location
1. ...
System
POWER DISTRIBUTION SYSTEM
POWER DISTRIBUTION SYSTEM : System Description
SYSTEM DESCRIPTION
• PDS (POWER DISTRIBUTION SYSTEM) is the system that BCM controls with the
operation of the pushbutton
ignition switch and performs the power distribution to each power circuit. This
system is used in ...
P0715 input speed sensor A
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
CAUTION:
Be careful of the driving speed.
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition
switch OFF and wait for at
least 10 seconds, then perform the next test.
> ...