Nissan Juke Service and Repair Manual : Diagnosis system (TCM)
CONSULT-III Function (TRANSMISSION)
CONSULT-III can display each diagnostic item using the diagnostic test modes shown below.
FUNCTION
*: “Function Test” can be selected, but do not use it.
WORK SUPPORT MODE
Display Item List
Engine Brake Adjustment
“ENGINE BRAKE LEVEL”
0: Initial set value (Engine brake level control is activated)
OFF: Engine brake level control is deactivated.
CAUTION:
Mode of “+1”“0”“−1”“−2”“OFF” can be selected by pressing the “UP”“DOWN” on
CONSULT-III screen.
However, do not select mode other than “0” and “OFF”. If the “+1” or “−1” or “–2” is selected, that might cause the irregular driveability.
Check CVT Fluid Deterioration Date
“CVTF DETERIORATION DATE” 210000 or more: It is necessary to change CVT fluid.
Less than 210000: It is not necessary to change CVT fluid.
CAUTION:
Touch “CLEAR” after changing CVT fluid, and then erase “CVTF DETERIORATION
DATE”.
SELF-DIAGNOSTIC RESULT MODE
Refer to TM-171, "DTC Index".
DATA MONITOR MODE
Display Items List
Diagnostic Tool Function
OBD SELF-DIAGNOSTIC PROCEDURE
(WITH GST)
Refer to EC-72, "Diagnosis Description".
On board diagnostic (OBD) system
Diagnosis Description DESCRIPTION The CVT system has two self-diagnostic systems. The first is the emission-related on board diagnostic system (OBD) performed by the TCM in combination with th ...Ecu diagnosis informatioN
TCM Reference Value VALUES ON THE DIAGNOSIS TOOL *1: Means CVT fluid temperature. Convert numerical values for actual fluid temperature °C (°F). Refer to TM-128, "ATFTEMP COUNT Conv ...Other materials:
P1643 thermoplunger control unit
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK THERMOPLUNGER CONTROL UNIT POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect thermoplunger control unit harness connector.
3. Check the voltage between thermoplunger control unit harness connector and
ground.
Is the ...
Diagnosis system (TCM)
Diagnosis description : 1 Trip Detection Diagnosis and 2 Trip Detection
Diagnosis
NOTE:
“Start the engine and turn OFF the ignition switch after warm-up.” This is
defined as 1 trip.
1 TRIP DETECTION DIAGNOSIS
When initial malfunction is detected, TCM memorizes DTC. In these diagnoses,
so ...
Brake booster
Inspection
OPERATION
Depress the brake pedal several times at 5-second intervals with the engine
stopped. Start the engine with the
brake pedal fully depressed. Check that the clearance between brake pedal and
dash lower panel decreases.
NOTE:
A slight impact with a small click may be fel ...