Nissan Juke Service and Repair Manual : Diagnosis system (navi control unit)
Diagnosis Description
On-Board Diagnosis Item • On-board diagnosis is performed in service test mode.
• On-board diagnosis checks if the system operates normally.
Service test mode
METHOD OF STARTING
1. Start the engine.
2. Turn OFF audio.
3. While pressing the “SET UP” switch, turn the MENU dial counterclockwise 3 clicks or more first, then clockwise and counterclockwise 3 clicks or more, respectively. (After the diagnosis mode starts, the initial screen of the diagnosis mode appears.)
END ON-BOARD DIAGNOSIS
Turn OFF ignition switch
System
System Diagram System Description Refer to Owner’s Manual for navigation and audio system operating instructions. Audio function and display are built into NAVI control unit. This navigati ...Ecu diagnosis information
NAVI CONTROL UNIT Reference Value TERMINAL LAYOUT PHYSICAL VALUES ...Other materials:
U1010 control unit (CAN)
Description
Initial diagnosis of A/C auto amp.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT-III
1. Turn ignition switch ON.
2. Select “Self Diagnostic Result” mode of “HVAC” using CONSULT-III.
3. Check DTC.
Is DTC detected?
...
In-cabin microfilter
The air conditioning system is equipped with an in-cabin microfilter which collects
dirt, pollen, dust, etc. To make sure the air conditioner heats, defogs, and ventilates
efficiently, replace the filter according to the specified maintenance log shown
in the NISSAN Service and Maintenance Gui ...
Water pump
Exploded View
1. Water pump
2. Gasket
3. Cylinder block
Removal and Installation
WARNING:
Never remove the radiator cap when the engine is hot. Serious burns could occur
from high pressure
coolant escaping from the radiator.
REMOVAL
1. Drain engine coolant. Refer to CO-62, "Drain ...