Nissan Juke Service and Repair Manual : Diagnosis systeM (BCM) (without intelligent key system)

Nissan Juke Service and Repair Manual / Defogger / System description / Diagnosis systeM (BCM) (without intelligent key system)

Common item

COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)

APPLICATION ITEM

CONSULT-III performs the following functions via CAN communication with BCM.

SYSTEM APPLICATION


SYSTEM APPLICATION

BCM can perform the following functions for each system.

NOTE

:
It can perform the diagnosis modes except the following for all sub system selection items.

• *1: This item is displayed, but is not used.


• *1: This item is displayed, but is not used.

• *2: For models with automatic A/C, this mode is not used.

Rear window defogger

REAR WINDOW DEFOGGER : CONSULT-III Function (BCM - REAR DEFOGGER)

Data monitor

ACTIVE TEST


ACTIVE TEST

Diagnosis system (IPDM E/R)


    Diagnosis system (BCM) (with intelligent key system)
    Common item COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perfo ...

    Diagnosis system (IPDM E/R)
    With intelligent key WITH INTELLIGENT KEY : Diagnosis Description AUTO ACTIVE TEST Description In auto active test mode, the IPDM E/R sends a drive signal to the following systems to check their ...

    Other materials:

    Key positions
    LOCK (0) The key can only be removed from the ignition switch at this position. OFF (1) The engine is turned off. The power supply is turned off. ACC (2) The electrical accessory power activates without the engine turned on. ON (3) The ignition system and the electrical accessory power activa ...

    U1000 can comm circuit
    Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each co ...

    Fuel pump
    Component Function Check 1.CHECK FUEL PUMP FUNCTION 1. Turn ignition switch ON. 2. Pinch fuel feed hose with two fingers. Fuel pressure pulsation should be felt on the fuel feed hose for 1 second after ignition switch is turned ON. Is the inspection result normal? YES >> INSPECTION END ...