Nissan Juke Service and Repair Manual : Diagnosis system (BCM) (without intelligent key system)
Common item
COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE
:
It can perform the diagnosis modes except the following for all sub system
selection items.
• *1: This item is displayed, but is not used.
• *2: For models with automatic A/C, this mode is not used.
Headlamp
HEADLAMP : CONSULT-III Function (BCM - HEAD LAMP)
WORK SUPPORT
*1: For models is without auto light system, this item is not displayed.
*2: Factory setting
DATA MONITOR
*1: Only models with front fog lamp can be monitored.
*2: Only models with auto light system can be monitored.
ACTIVE TEST
*1: For models without front fog lamp, this item is displayed but active test is not operated.*1: For models without front fog lamp, this item is displayed but active test is not operated.
*2: For models without daytime running light system, this item is not displayed.
*2: For models without daytime running light system, this item is not displayed.
Flasher
FLASHER : CONSULT-III Function (BCM - FLASHER)
DATA MONITOR
ACTIVE TEST
Diagnosis system (BCM) (with intelligent key system)
Common item COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perfo ...Diagnosis system (ipdm e/r) (with intelligent key system)
Diagnosis Description AUTO ACTIVE TEST Description In auto active test mode, the IPDM E/R sends a drive signal to the following systems to check their operation. • Oil pressure warning lamp (o ...Other materials:
Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
DETAILED FLOW
1.OBTAIN INFORMATION ABOUT SYMPTOM
Interview the customer to obtain as much malfunction information (conditions
and environment when the malfunction
occurred) as possible when the customer brings the vehicle in.
>> GO TO 2.
2. ...
P0327, P0328 KS
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition swit ...
C1604 torque sensor
DTC Logic
DTC DETECTION LOGI
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE
With C ...