Nissan Juke Service and Repair Manual : Diagnosis system (BCM) (without intelligent key system)
Common item : consult-III Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE
:
It can perform the diagnosis modes except the following for all sub system
selection items.
• *1: This item is displayed, but is not used.
• *2: For models with automatic A/C, this mode is not used.
Air conditioner : consult-III Function (BCM - AIR CONDITIONER) (Automatic A/C 4WD Models)
DATA MONITOR
Display Item List
Diagnosis system (BCM) (with intelligent key system)
Common item : consult-III Function (BCM - common item) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the follow ...Other materials:
P1551, P1552 battery current sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following before conducting
the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. ...
Power supply and ground circuit
Diagnosis Procedure
1.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) IGNITION POWER
SUPPLY
1. Turn the ignition switch OFF.
2. Disconnect ABS actuator and electric unit (control unit) harness connector.
3. Check voltage between ABS actuator and electric unit (control unit) harness
conne ...
Wheel Alignment
HR16DE, K9K
Measure value under unladen*2 conditions.
*1: Since adjustment mechanism is not included, the value of the left and right
wheels (both wheels) must be
used as the standard value.
*2: Fuel, engine coolant and lubricant are full. Spare tire, jack, hand tools
and mats are in des ...