Nissan Juke Service and Repair Manual : Diagnosis system (BCM) (with intelligent key system)
Common item
COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE
:
It can perform the diagnosis modes except the following for all sub system
selection items.
NOTE
:
• *1: This item is displayed, but not used.
• *2: For models with automatic A/C, this diagnosis mode is not used.
FREEZE FRAME DATA (FFD)
The BCM records the following vehicle condition at the time a particular DTC is detected, and displays on CONSULT-III.
Headlamp
HEADLAMP : CONSULT-III Function (BCM - HEAD LAMP)
WORK SUPPORT
*1: For models is without auto light system, this item is displayed but work support is not operated.
*2: Factory setting
DATA MONITOR
*: For models without auto light system, this is not displayed.
ACTIVE TEST
*: For models without daytime running light system, this item is not displayed.
Flasher
FLASHER : CONSULT-III Function (BCM - FLASHER)
WORK SUPPORT
*: Factory setting DATA MONITOR
ACTIVE TEST
System
Headlamp system HEADLAMP SYSTEM : System Diagram HEADLAMP SYSTEM : System Description OUTLINE Headlamp is controlled by combination switch reading function and headlamp control function of BCM ...Diagnosis system (BCM) (without intelligent key system)
Common item COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perfo ...Other materials:
P173B 1GR incorrect ratio
DTC Logic
DTC CONFIRMATION PROCEDURE
CAUTION:
• Be sure to perform “TM-445, "Diagnosis Procedure"” and then perform “DTC
CONFIRMATION PROCEDURE”.
• Never perform "DTC CONFIRMATION PROCEDURE" before the repairs. Doing so may
result in a secondary
malfunction.
• Be carefu ...
P0778 pressure control solenoid B
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn
ignition switch
OFF and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the mal ...
B2636, B2637, B2638, B2639, B2654, B2655 mode door motor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT-III
1. Turn ignition switch ON.
2. Select “Self Diagnostic Result” mode of “HVAC” using CONSULT-III.
3. Check DTC.
Is DTC detected?
YES >> Refer to HAC-157, "Diagnosis P ...