Nissan Juke Service and Repair Manual : Diagnosis system (BCM)

Common item

COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)

APPLICATION ITEM

CONSULT-III performs the following functions via CAN communication with BCM.

SYSTEM APPLICATION


SYSTEM APPLICATION

BCM can perform the following functions for each system.

NOTE

:
It can perform the diagnosis modes except the following for all sub system selection items.

• *1: This item is displayed, but is not used.


• *1: This item is displayed, but is not used.

• *2: For models with automatic A/C, this mode is not used.

Door lock

DOOR LOCK : CONSULT-III Function (BCM - DOOR LOCK) (Without Super Lock)

WORK SUPPORT

*: P range interlock door lock/unlock can be selected for M/T models, but


*: P range interlock door lock/unlock can be selected for M/T models, but automatic door lock/unlock function does not operate.

DATA MONITOR


ACTIVE TEST


ACTIVE TEST

Multi remote ent


Multi remote ent

MULTI REMOTE ENT : CONSULT-III Function (BCM - MULTI REMOTE ENT) (Without Super Lock)

DATA MONITOR

ACTIVE TEST


ACTIVE TEST

WORK SUPPORT


WORK SUPPORT

Trunk


Trunk

TRUNK : CONSULT-III Function (BCM - TRUNK) (Without Super Lock)

DATA MONITOR

ECU diagnosis information


    Back door opener system
    System Diagram System Descr BACK DOOR OPENER OPERATION When back door opener switch is pressed, BCM operates back door opener actuator. NOTE: Back door opener actuator is not for locking th ...

    ECU diagnosis information
    BCM List of ECU Reference ...

    Other materials:

    Wiring diagram
    METER SYSTEM Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation". ...

    P0643 sensor power supply
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

    NISSAN Vehicle Immobilizer System
    The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of the registered key. If the engine fails to start using the registered key, it may be due to interference caused by another registered key, an automated toll road device or automated payment device on t ...