Nissan Juke Service and Repair Manual : Diagnosis system (A/C auto AMP.)
Description
Air conditioning system performs self-diagnosis, operation check, function diagnosis, and various settings using diagnosis function of each control unit.
CONSULT-III Function
CONSULT-III performs the following functions via CAN communication with A/C auto amp.
NOTE
:
Diagnosis should be performed with engine running. Door motor operation speeds
become slower and NO
results may be returned even for normal operation if battery voltage drops below
12 V during self-diagnosis.
ECU IDENTIFICATION
Part number of A/C auto amp. can be checked.
SELF-DIAGNOSIS RESULTS
Diagnosis result that is judged by A/C auto amp. can be checked. Refer to HAC-130, "DTC Index".
DATA MONITOR
Input/output signal of A/C auto amp. can be checked.
Display item list
*: “DUTY” is displayed, but voltage is indicated. Or unit is not displayed but unit is (V).
ACTIVE TEST
The signals used to activate each device forcibly supplied from A/C auto amp. operation check of air conditioning system can be performed.
Check each output device
NOTE
:
Perform the inspection of each output device after starting the engine because
the compressor is operated.
WORK SUPPORT
Setting change of each setting functions can be performed.
NOTE
:
When the battery cable is disconnected from the negative terminal or when the
battery voltage becomes 10 V
or less, the setting of WORK SUPPORT may be cancelled.
Operation
Switch Name and Function OPERATION AND DISPLAY A/C Display (Display in Multi Display Unit) • Air conditioning system operation status is indicated on display in multi display unit. Indication o ...Diagnosis system (BCM) (with intelligent key system)
Common item : consult-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the follow ...Other materials:
Engine protection control at low engine oil pressure
Engine protection control at low engine oil pressure : System Diagram
Engine protection control at low engine oil pressure : System Description
INPUT/OUTPUT SIGNAL CHART
SYSTEM DESCRIPTION
• The engine protection control at low engine oil pressure warns the driver
of a decrease in engine ...
Hazard function
Component Function Check
1.CHECK FUNCTION
1. Select “MULTI REMOTE ENT” of “BCM” using CONSULT-III.
2. Select “FLASHER” in “ACTIVE TEST” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Hazard warning lam ...
Periodic maintenance
REAR WHEEL HUB
Inspection
COMPONENT PART
Check the mounting conditions (looseness, back lash) of each component and
component conditions (wear,
damage) are normal.
WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE)
Check the following items, and replace the part it necessary.
• Move wheel hub ...