Nissan Juke Service and Repair Manual : Diagnosis system (4WD control module)

CONSULT-III Function

APPLICATION ITEMS

CONSULT-III can display each diagnostic item using the diagnostic test modes as follows.

*: The following diagnosis information is erased by erasing.


*: The following diagnosis information is erased by erasing.

• DTC
• Freeze frame data (FFD)

ECU IDENTIFICATION

4WD control module part number can be read.

SELF DIAGNOSTIC RESULT

Refer to DLN-33, "DTC Index".

When “PRSNT” is displayed on self-diagnosis result.

• The system is presently malfunctioning.

When “PAST” is displayed on self-diagnosis result.

• System malfunction in the past is detected, but the system is presently normal.

FREEZE FRAME DATA (FFD)

The following vehicle status is recorded when DTC is detected and is displayed on CONSULT-III.


DATA MONITOR


DATA MONITOR


ACTIVE TEST


ACTIVE TEST

Use this mode to determine and identify the details of a malfunction based on self-diagnostic results or data monitor. 4WD control module gives drive signal to actuator with receiving command from CONSULT-III to check operation of actuator.

CAUTION:


CAUTION:
Never energize continuously for a long time.

WORK SUPPORT

ECU diagnosis information


    System
    4WD system : System Diagram INPUT/OUTPUT SIGNAL It transmits/receives each signal from the following 4WD control module via CAN communication line. 4WD system : System Description • 4WD mo ...

    ECU diagnosis information
    4WD control module Reference Value VALUES ON THE DIAGNOSIS TOOL TERMINAL LAYOUT PHYSICAL VALUES *: The values are changed by throttle opening and engine speed. CAUTION: When using ...

    Other materials:

    Operation inspection
    Work Procedure The purpose of the operational check is to check that the individual system operates normally. Check condition : Engine running at normal operating temperature. 1.CHECK BLOWER MOTOR 1. Operate fan control dial. 2. Check that fan speed changes. Check operation for all fan speeds ...

    P1612 chain of ECM-IMMU
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC P1612 is displayed with DTC U1000 (for BCM), first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC P1612 is displayed with DTC U1010 (for BCM), first perform the trouble diagnosis for DTC U1010. ...

    Cooling fan control
    Cooling fan control : System Diagram Cooling fan control : System Description INPUT/OUTPUT SIGNAL CHART *: The ECM determines the start signal status by the signals of engine speed and battery voltage. SYSTEM DESCRIPTION ECM controls cooling fan speed corresponding to vehicle speed, eng ...