Nissan Juke Service and Repair Manual : Defogger
- Precaution
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution Necessary for Steering Wheel Rotation after Battery Discon
- Precaution for Procedure without Cowl Top Cover
- System description
- Component parts
- System
- Diagnosis system (BCM) (with intelligent key system)
- Diagnosis systeM (BCM) (without intelligent key system)
- Diagnosis system (IPDM E/R)
- Ecu diagnosis information
- Basic inspection
- DTC/circuit diagnosis
- Rear window defogger switch
- Rear window defogger relay
- Rear window defogger
- Door mirror defogger
- Driver side door mirror defogger
- Passenger side door mirror defogger
- Rear window defogger on signal
- Rear window defogger system
- Symptom diagnosis
- All defogger system dose not operate
- Rear window defogger does not operate but both door mirror defoggers operate
- Door mirror defogger does not operate
- On is not displayed when pressing rear window defogger switch but it is operated
- Rear window defogger indicator does not illuminate
- Removal and installation
Rear washer nozzle and tube
Hydraulic Layout 1. Rear washer nozzle 2. Plug 3. Rear washer tube 4. Joint 5. Second washer tube 6. Back door seal rubber 7. Front washer tube : Clip : Pawl Removal and Installation ...Precaution
...Other materials:
C1101, C1102, C1103, C1104 WHEEL SENSOR
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...
Back door opener actuator
Component Function Check
1.CHECK FUNCTION
1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.
2. Select “TRUNK/BACK DOOR” in “ACTIVE TEST” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Back door o ...
Reference Value
VALUES ON THE DIAGNOSIS TOOL
Remarks:
• Specification data are reference values.
• Specification data are output/input values
which are detected or supplied by the ECM at the connector.
* Specification data may not be directly related to their components
signals/values/operations.
I.e. ...