Nissan Juke Service and Repair Manual : CVT position

Inspection and Adjustment

INSPECTION

1. Place selector lever in “P” position, and turn ignition switch ON (engine stop).

2. Make sure that selector lever can be shifted to other than “P” position when brake pedal is depressed. Also make sure that selector lever can be shifted from “P” position only when brake pedal is depressed.

3. Move the selector lever and check for excessive effort, sticking, noise or rattle.

4. Confirm the selector lever stops at each position with the feel of engagement when it is moved through all the positions. Check that the actual position of the selector lever matches the position shown by the shift position indicator and the manual lever on the transaxle.

5. The method of operating the selector lever to individual positions correctly should be as shown.

6. When selector button is pressed in “P”, “R” or “N” position without applying forward/backward force to selector lever, check button operation for sticking.

7. Confirm the back-up lamps illuminate only when selector lever is placed in the “R” position. Confirm the back-up lamps do not illuminate when the selector lever is pushed toward the “R” position when in the “P” or “N” position.

8. Confirm the engine can only be started with the selector lever in the “P” and “N” positions.

9. Make sure transaxle is locked completely in “P” position.

10. When selector lever is set to manual shift gate, make sure that manual mode is displayed on combination meter.

Shift selector lever to “+” and “–” sides, and check that set shift position changes.

ADJUSTMENT


ADJUSTMENT

1. Place selector lever in “P” position.

CAUTION:
Turn wheels more than 1/4 rotations and apply the park lock.

2. Loosen nut (A) and place manual lever (B) in “P” position.

CAUTION:
Never apply any force to the manual lever.

3. Tighten nut. Refer to TM-273, "Removal and Installation".

CAUTION:
Fix the manual lever when tightening.

DTC/Circuit diagnosis


    Road test
    Description DESCRIPTION • The purpose of the test is to determine overall performance of CVT and analyze causes of problems. • The road test consists of the following three parts: 1. “Check Befor ...

    Other materials:

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...

    Basic inspection
    Diagnosis and repair workflow Trouble Diagnosis Flow Chart Trouble Diagnosis Procedure INTERVIEW WITH CUSTOMER Interview with the customer is important to detect the root cause of CAN communication system errors and to understand vehicle condition and symptoms for proper trouble diagnosis. ...

    P2135 TP sensor
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P2135 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643. Refer to EC-307, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform ...