Nissan Juke Service and Repair Manual : CSC (concentric slave cylinder)

Exploded View

1. Transaxle assembly


1. Transaxle assembly 2. CSC (Concentric Slave Cylinder)

disassembly.: Always replace after every
disassembly.

Removal and Installation: N·m (kg-m, ft-lb)


Removal and Installation

CAUTION:
• Never reuse CSC (Concentric Slave Cylinder). Because CSC slides back to the original position every time when removing transaxle assembly. At this timing, dust on the sliding parts may damage a seal of CSC and may cause clutch fluid leakage.

• Never disassemble CSC.

• Keep painted surface on the body or other parts free of clutch fluid. If it spills, wipe up immediately and wash the affected area with water.

REMOVAL

1. Remove transaxle assembly. Refer to TM-30, "Removal and Installation" (RS5F92R), or TM-84, "MR16DDT : Removal and Installation" (RS6F94R with MR16DDT), TM-86, "K9K : Removal and Installation" (RS6F94R with K9K).

2. Remove CSC from clutch housing.

INSTALLATION

1. Install CSC to clutch housing, and then tighten CSC mounting bolts to the specified torque.

CAUTION:
• Never reuse CSC.

• Never insert and operate CSC because piston and stopper of CSC components may fall off.

2. For the next step and after, install in the reverse order of removal.

Inspection and Adjustment

INSPECTION AFTER INSTALLATION

Check the fluid leakage and the fluid level. Refer to CL-10, "RS5F92R : Inspection" (RS5F92R) or CL-13, "RS6F94R : Inspection" (RS6F94R).

ADJUSTMENT AFTER INSTALLATION

Perform the air bleeding. Refer to CL-12, "RS5F92R : Air Bleeding" (RS5F92R) or CL-15, "RS6F94R : Air Bleeding" (RS6F94R).

    Clutch disc and clutch cover
    Except for K9K : Exploded View HR16DE 1. Flywheel 2. Clutch disc 3. Clutch cover 4. Input shaft A. First step B. Final step : N·m (kg-m, ft-lb) : Apply lithium-based grease including m ...

    Other materials:

    B2014 chain of STRG-IMMU
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Lock steering. NOTE: 3. Press the push-button ignition switch. 4. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III. Is DTC detected? YES >> Go to SEC-70, " ...

    Headlamp washer system
    Wiring Diagram - HEADLAMP WASHER SYSTEM - For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation". ...

    Engine maintenance (K9K)
    Drive belt DRIVE BELT : Checking Drive Belts WARNING: Be sure to perform when the engine is stopped. 1. Inspect belts for cracks, fraying, wear and oil. If necessary, replace. 2. Evaluate manually if the belt is enough tensioned (tension cannot be measured by way of frequency meter). CAU ...