Nissan Juke Owners Manual : Corrosion protection
- Most common factors contributing to vehicle corrosion
- Environmental factors influence the rate of corrosion
- To protect your vehicle from corrosion
Seat belts
The seat belts can be cleaned by wiping them with a sponge dampened in a mild soap solution. Allow the belts to dry completely in the shade before using them. See “Seat belts” . WARNING Do not al ...Most common factors contributing to vehicle corrosion
• The accumulation of moisture-retaining dirt and debris in body panel sections, cavities, and other areas. • Damage to paint and other protective coatings caused by gravel and stone chips or min ...Other materials:
P062B ECM
Description
This DTC is detected when the ECM-integrated injector driver unit has a
malfunction. For injector driver unit,
refer to EC-31, "ECM".
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
1. Turn ignition switch OFF and wait at least 10 seconds.
...
Back door opener switch
Component Function Check
1.CHECK FUNCTION
1. Select “TRUNK” of “BCM” using CONSULT-III.
2. Select “TRNK OPNR SW” in “DATA MONITOR” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Back door opener switch ...
Refrigerant pressure sensor
Component Function Check
1.CHECK REFRIGERANT PRESSURE SENSOR OVERALL FUNCTION
1. Start engine and warm it up to normal operating temperature.
2. Turn A/C switch and blower fan switch ON.
3. Check the voltage between ECM harness connector and ground.]
Is the inspection result normal?
YES > ...