Nissan Juke Service and Repair Manual : Cooling fan

Exploded View

1. Fan motor


1. Fan motor
2. Fan shroud
3. Cooling fan

A. Apply on fan motor shaft

: Apply genuine high strength thread: N·m (kg-m, in-lb)
locking sealant or equivalent.: Apply genuine high strength thread
locking sealant or equivalent.

Removal and Installation

REMOVAL

1. Drain engine coolant. Refer to CO-11, "Draining".

CAUTION:
• Perform this step engine is cold.

• Never spill engine coolant on drive belt.

2. Remove engine cover.

3. Remove front bumper. Refer to EXT-12, "Exploded View".

4. Remove radiator core support upper. Refer to DLK-149, "MR16DDT : Exploded View".

5. Disconnect cooling fan harness connector.

6. Remove reservoir tank. Refer to CO-17, "Exploded View".

7. Remove radiator hose (upper). Refer to CO-17, "Exploded View".

8. Remove cooling fan assembly.

CAUTION:
Be careful not to damage or scratch on radiator core when removing.

INSTALLATION

Note the following, and install in the reverse order of removal.

CAUTION:
Only use genuine parts for fan shroud mounting bolt and observe the specified torque (to prevent radiator from being damaged).

NOTE:

Cooling fan is controlled by ECM. For details, Refer to EC-774, "Component Function Check".

Disassembly and Assembly

DISASSEMBLY

1. Remove cooling fan mounting nut, and then remove the cooling fan.

2. Remove fan motor.

ASSEMBLY

Note the following, and assemble in the reverse order of disassembly.

• Apply genuine high strength thread locking sealant on fan motor shaft.

Inspection

Cooling Fan
Inspect cooling fan for crack or unusual bend.

• If anything is found, replace cooling fan.

    Radiator
    Exploded View 1. Cooling fan assembly 2. Mounting rubber (upper) 3. Radiator 4. Mounting rubber (lower) 5. O-ring 6. Drain plug 7. Clamp 8. Radiator hose (lower) (LH) 9. Reservoir tank h ...

    Water pump
    Exploded View 1. Gasket 2. Water pump : N·m (kg-m, ft-lb) : Always replace after every disassembly. Removal and Installation REMOVAL 1. Drain engine coolant from radiator. Refer to CO-11, ...

    Other materials:

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver a ...

    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
    The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is include ...

    Audio operation precautions
    Radio Place the ignition switch in the ACC or ON position and push the PWR (power/VOL (volume)) control to turn on the radio. If you listen to the radio with the engine not running, the ignition switch should be placed in the ACC position. Radio reception is affected by station signal strength ...