Nissan Juke Service and Repair Manual : Compressor dose dot operate

Description

SYMPTOM

Compressor dose not operate.

Diagnosis Procedure

NOTE

:
• Perform self-diagnoses with CONSULT-III before performing symptom diagnosis. If any DTC is detected, perform the corresponding diagnosis.

• Check that refrigerant is enclosed in cooler cycle normally. If refrigerant amount is shortage from proper amount, perform the inspection of refrigerant leakage.

1.CHECK MAGNET CLUTCH OPERATION

Check magnet clutch. Refer to HAC-175, "Component Function Check".

Does it operate normally? YES >> GO TO 2.

NO >> Repair or replace malfunctioning parts.

2.CHECK REFRIGERANT PRESSURE SENSOR

Check refrigerant pressure sensor. Refer to the following.

• HR16DE: Refer to EC-790, "Component Function Check".

• MR16DDT: Refer to EC-423, "Component Function Check".

• K9K: Refer to EC-960, "DTC Logic".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace malfunctioning parts.

3.CHECK A/C ON SIGNAL

Check A/C ON signal. Refer to HAC-166, "Component Function Check".

Is inspection result normal? YES >> GO TO 4.

NO >> Repair or replace malfunctioning parts.

4.CHECK BLOWER FAN ON SIGNAL

Check blower fan ON signal. Refer to HAC-168, "Component Function Check".

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair or replace malfunctioning parts 5.CHECK BCM OUTPUT SIGNAL

1. Select “DATA MONITOR” mode of “ECM” using CONSULT-III.With CONSULT-III


1. Select “DATA MONITOR” mode of “ECM” using CONSULT-III.

2. Select “AIR COND SIG” and “HEATER FAN SW”, and check status under the following conditions.

Is the inspection result normal?


Is the inspection result normal? YES >> Replace IPDM E/R. Refer to PCS-34, "Removal and Installation" (with Intelligent Key) or PCS-63, "Removal and Installation" (without Intelligent Key).

NO >> Replace BCM. Refer to BCS-93, "Removal and Installation" (with Intelligent Key) or BCS-161, "Removal and Installation" (without Intelligent Key).

    Insufficient heating
    Description Symptom • Insufficient heating • No warm air comes out. (Air flow volume is normal.) Diagnosis Procedure NOTE: Perform self-diagnoses with CONSULT-III before performing symptom diagn ...

    Other materials:

    C1120, C1122, C1124, C1126 ABS in valve system
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT ...

    Refilling
    1. Install reservoir tank if removed and radiator drain plug. CAUTION: Be sure to clean drain plug and install with new O-ring. Radiator drain plug : Refer to CO-42, "Exploded View". • If water drain plugs on cylinder block are removed, close and tighten them. Refer to EM-228, &quo ...

    Engine smokes when revved
    Description CHART 20: ENGINE SMOKES WHEN REVVED Diagnosis Procedure 1.CHECK ENGINE OIL Check the grade of engine oil. Refer to LU-25, "Inspection". Is the inspection result normal? YES >> GO TO 2. NO >> Replace engine oil. Refer to LU-26, "Refilling". 2. ...