Nissan Juke Service and Repair Manual : Component parts
Component Parts Location
1. A/C auto amp
Refer to HAC-12, "Component Parts
Location"
2. ECM
Refer to EC-25, "ENGINE CONTROL
SYSTEM :
Component Parts Location"
3. TCM
Refer to TM-314, "CVT CONTROL
SYSTEM : Component Parts Location"
4. EPS control unit
Refer to STC-5, "Component Parts
Location"
5. Drive mode switch
• NORMAL switch
• SPORT switch
• ECO switch
6. D-MODE select switch
A. Multi display unit
Component Description
Multi Display Unit
DESCRIPTION
• The multi display unit connects to other units via CAN communication and performs the drive mode control.
• The following 3 drive modes are available, NORMAL, SPORT, and ECO.
• The drive mode can be changed over as desired by pressing the D-MODE select switch. The characteristics of the engine, CVT, steering and air conditioner are changed accordingly.
• The display shows the current drive mode (NORMAL, SPORT, ECO) as well as the vehicle information for the mode.
VEHICLE INFORMATION DISPLAY
Drive Mode
System
System Description SYSTEM DIAGRAM • The multi display unit transmits the operation status of the drive mode switch to other units via CAN communication as the mode signal (refer below). - NO ...Other materials:
P1564 ASCD steering switch
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P1564 is displayed with DTC P0605, first perform the trouble diagnosis
for DTC P0605. Refer to
EC-302, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform ...
Throttle valve closed position learning
Description
Throttle Valve Closed Position Learning is a function of ECM to learn the
fully closed position of the throttle
valve by monitoring the throttle position sensor output signal. It must be
performed each time harness connector
of electric throttle control actuator or ECM is disconne ...
Take away warning does not operate
Diagnosis Procedure
1.CHECK DTC WITH BCM AND COMBINATION METER
Check that DTC is not detected with BCM and combination meter.
Is the inspection result normal?
YES >> GO TO 2.
NO-1 >> Refer to BCS-67, "DTC Index". (BCM)
NO-2 >> Refer to MWI-36, "DTC Index&qu ...