Nissan Juke Service and Repair Manual : Component parts

Component Parts Location

LHD MODELS

1. Multi display unit


1. Multi display unit 2. ABS actuator and electric unit (control unit)
3. A/C auto amp. (With auto air conditioning) PTC heater control unit (Diesel engine with manual air conditioning) 4. ECM (Gasoline engine models) 5. IPDM E/R
6. TCM (Gasoline engine models) ECM (Diesel engine models) 7. EPS control unit
8. Combination meter
9. BCM
10. Data link connector 11. Steering angle sensor 12. 4WD control module
13. Air bag diagnosis sensor unit

RHD MODELS

1. Steering angle sensor


1. Steering angle sensor 2. Data link connector
3. Combination meter
4. EPS control unit
5. A/C auto amp. (With auto air conditioning) PTC heater control unit (Diesel engine with manual air conditioning) 6. ABS actuator and electric unit (control unit)
7. ECM (Gasoline engine models) 8. IPDM E/R
9. TCM (Gasoline engine models) ECM (Diesel engine models) 10. BCM
11. Multi display unit
12. 4WD control module
13. Air bag diagnosis sensor unit

    System
    Can communication system CAN COMMUNICATION SYSTEM : System Diagram CAN COMMUNICATION SYSTEM : System Description Description • CAN (Controller Area Network) is a serial communication line for re ...

    Other materials:

    Camshaft valve clearance
    Valve Clearance CHECKING AND ADJUSTING THE VALVE CLEARANCE 1. Install the tappet. 2. Install the camshaft. 3. Install the camshaft brackets. : 11 N·m (1.1 kg-m, 8 ft-lb) 4. Place the valves of the cylinder concerned at the “end of exhaust - beginning of inlet” position and check the clearance ...

    Radiator
    Exploded View 1. Reservoir tank cap 2. Reservoir tank 3. Clamp 4. Reservoir tank hose 5. Mounting rubber (upper) 6. Reservoir tank hose 7. Radiator 8. Mounting rubber (lower) 9. Drain plug 10. O-ring 11. Cooling fan assembly 12. Radiator hose (upper) 13. Radiator hose (lower) ...

    Normal operating condition
    Description FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED) If the engine speed is above 1,800 rpm under no load (for example, the selector lever position is neutral and engine speed is over 1,800 rpm) fuel will be cut off after some time. The exact time when the fuel is cut off varies b ...