Nissan Juke Service and Repair Manual : Component parts
Component Parts Location
1. Hazard switch
2. Parking lamp
3. Front turn signal lamp
4. Front fog lamp*1
5. Headlamp
6. ECM
Refer to EC-461, "ECM".
7. IPDM E/R Refer to PCS-5, "Component Parts Location".
8. BCM Refer to BCS-6, "BODY CONTROL SYSTEM : Component Parts Location".
9. Combination switch
10. Combination meter
11. Light & rain sensor*2
12. Side turn signal lamp
13. Headlamp aiming switch
14. Front door switch (driver side)
15. Rear turn signal lamp
16. Tail lamp
17. Rear fog lamp
18. License plate lamp
19. Daytime running light relay*3
20. Aiming motor
A. Engine room (RH)
B. Headlamp (back)
*1: With front fog lamp models *2: With auto light system *3: With daytime running light system
Component Description
Light & Rain Sensor
• The light & rain sensor detects the outside ambient light level, forward light level and sensor conditions.
• Based on ambient light level (day/night detection), forward light level (tunnel detection) and sensor conditions it judges ON/OFF condition for exterior lamps.
• And it transmits exterior lamp ON/OFF request to the BCM by the light & rain sensor serial link.
• BCM controls each function depending on the signals. And it detects the light & rain sensor serial link error and the light & rain sensor malfunction.
System
Headlamp system HEADLAMP SYSTEM : System Diagram HEADLAMP SYSTEM : System Description OUTLINE Headlamp is controlled by combination switch reading function and headlamp control function of BCM ...Other materials:
SRS air bag warning lamp does not turn off
Diagnosis Procedure
1.CHECK AIR BAG MODULE AND SEAT BELT PRE-TENSIONER
Check the deployment of air bag module.
Is air bag module deployed?
YES >> Replace the malfunctioning parts.
NO >> GO TO 2.
2.CHECK AIR BAG FUSE
Check 10 A fuse [No.2, located in fuse block (J/B)].
Is ...
Water outlet
Exploded View
1. Heater pipe bracket
2. Radiator cap
3. Water outlet adaptor
4. Clamp
5. Water outlet hose
6. Clamp
7. Heater hose
8. Clamp
9. Water outlet
10. Clamp
11. Heater hose
12. Heater hose
13. Clamp
14. Heater hose
15. Clamp
16. Engine coolant temperature sensor ...
B26F7 BCM
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Press door request switch.
2. Turn ignition switch ON.
3. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.
Is DTC detected?
YES >> Go to SEC-127, "Diagnosis P ...