Nissan Juke Service and Repair Manual : Component parts
Component Parts Location
1. Intelligent Key warning buzzer
2. Remote keyless entry receiver
3. Inside key antenna (instrument center)
4. TCM
Refer to TM-133, "CVT CONTROL
SYSTEM : TCM" (RE0F10B models)
or TM-316, "CVT CONTROL SYSTEM
: TCM" (RE0F11A models)
5. Push-button ignition switch
6. Combination meter
7. BCM
Refer to BCS-6, "BODY CONTROL
SYSTEM : Component Parts Location"
8. Power window switch (driver side)
(door lock and unlock switch)
9. Outside key antenna (driver side)
10. Front door switch (driver side)
11. Front door lock assembly (driver side)
12. Front door request switch (driver side)
13. Inside key antenna (console)
14. Inside key antenna (luggage room)
15. Back door request switch
16. Back door lock assembly
17. Outside antenna (rear bumper)
18. Front door request switch (passenger
side)
19. Outside key antenna (passenger side)
20. Air bag diagnosis sensor unit
Refer to SRC-7, "Component Parts
Location"
A. View with front bumper removed
B. View with instrument panel assembly
removed
C. View with multi display unit removed
D. View with center console assembly removed
E. View with luggage room finisher removed
F. View with rear bumper removed
Component Description
System (power door lock system)
System Diagram System Description DOOR LOCK FUNCTION Door Lock and Unlock Switch • The door lock and unlock switch (driver side) is build into power window main switch. • Interlocked with the ...Other materials:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and front passenger for certain
types of collision. Information necessary to service the system safely is
include ...
B1146 curtain air bag module RH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1.INTERVIEW FOR MALFUNCTION
Interview the symptom to the customer.
>> GO TO 2.
2.SYMPTOM CHECK
Check the symptom from the customer's information.
>> GO TO 3.
3.BASIC INSPECTION
Check the operation o ...