Nissan Juke Service and Repair Manual : Combination switch output circuit
Diagnosis Procedure
1.CHECK OUTPUT 1 - 5 CIRCUIT FOR OPEN
1. Turn ignition switch OFF.
2. Disconnect BCM and combination switch connectors.
3. Check continuity between BCM harness connector and combination switch harness connector.
Does continuity exist? YES >> GO TO 2.
NO >> Repair harnesses or connectors.
2.CHECK OUTPUT 1 - 5 CIRCUIT FOR SHORT
Check for continuity between BCM harness connector and ground.
Does continuity exist? YES >> Repair harnesses or connectors.
NO >> GO TO 3.
3.CHECK BCM OUTPUT VOLTAGE
1. Connect BCM connector.
2. Check voltage between BCM harness connector and ground.
Is the measurement value normal?
YES >> Replace combination switch.
NO >> Replace BCM. Refer to BCS-93, "Removal and Installation".
Power supply and ground circuit
Diagnosis Procedure 1.CHECK FUSE AND FUSIBLE LINK Check that the following fuse and fusible link are not blown. Is the fuse fusing? YES >> Replace the blown fuse or fusible link after repa ...Combination switch input circuit
Diagnosis Procedure 1.CHECK INPUT 1 - 5 CIRCUIT FOR OPEN 1. Turn ignition switch OFF. 2. Disconnect BCM and combination switch connectors. 3. Check continuity between BCM harness connector and com ...Other materials:
Light & rain sensor
Exploded View
1. Light & rain sensor bracket
2. Mirror base
3. Light & rain sensor
4. Inside mirror assembly
: Pawl
: Do not reuse
Removal and Installation
CAUTION:
When the light & rain sensor is removed from windshield, the light & rain sensor
cannot be reused.
REMO ...
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...
Vehicle does not enter 4WD mode
Description
Vehicle does not enter 4-wheel drive mode even though 4WD warning lamp turned
to OFF.
Diagnosis Procedure
1.CHECK 4WD WARNING LAMP
Turn the ignition switch ON.
Does 4WD warning lamp turn ON?
YES >> GO TO 2.
NO >> Proceed to diagnosis procedure. Refer to DLN-80, & ...