Nissan Juke Service and Repair Manual : Charging system preliminary inspection
Inspection Procedure
1.CHECK BATTERY TERMINALS CONNECTION
Check if battery terminals are clean and tight.
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair battery terminals connection.
2.CHECK FUSE
Check for blown fuse and fusible link.
Is the inspection result normal? YES >> GO TO 3.
NO >> Be sure to eliminate the cause of malfunction before installing new fuse.
3.CHECK “E” TERMINAL CONNECTION (ALTERNATOR GROUND)
Check if “E” terminal (alternator ground) is clean and tight.
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair “E” terminal (alternator ground) connection.
4.CHECK DRIVE BELT TENSION
Check drive belt tension. Refer to the following.
• HR16DE engine models: EM-154, "Checking" • MR16DDT engine models: EM-20, "Checking" • K9K engine models: EM-276, "Checking Drive Belts"
Is the inspection result normal? YES >> INSPECTION END
NO >> Repair as needed.
Diagnosis and repair workflow
Gasoline engine models GASOLINE ENGINE MODELS : Work Flow OVERALL SEQUENCE DETAILED FLOW 1.PRELIMINARY INSPECTION Perform the preliminary inspection. Refer to CHG-17, "Inspection Procedure ...Power generation voltage variable control system operation inspection
Inspection Procedure CAUTION: When performing this inspection, always use a charged battery that has completed the battery inspection. (When the charging rate of the battery is low, the respons ...Other materials:
Intelligent key warning buzzer
Component Function Check
1.CHECK FUNCTION
1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.
2. Select “OUTSIDE BUZZER” in “ACTIVE TEST” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Intelligent ...
P0197, P0198 EOT sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition swit ...
B2321, B2322 oil level sensor
Description
The oil level sensor detects the level of engine oil, and then transmits the
oil level signal to the combination
meter.
DTC Logic
DTC DETECTION LOGIC
NOTE:
When the following conditions are satisfied, the combination meter reads the
resistance value of oil level sensor.
Th ...