Nissan Juke Owners Manual : Car phone or CB radio

When installing a car phone or a CB radio in your vehicle, be sure to observe the following precautions, otherwise the new equipment may adversely affect the electronic control modules and electronic control system harness.

WARNING

•  A cellular phone should not be used for any purpose while driving so full attention may be given to vehicle operation. Some jurisdictions prohibit the use of cellular phones while driving.

•  If you must make a call while your vehicle is in motion, the hands-free cellular phone operational mode (if so equipped) is highly recommended.

Exercise extreme caution at all times so full attention may be given to vehicle operation.

•  If a conversation in a moving vehicle requires you to take notes, pull off the road to a safe location and stop your vehicle before doing so.

CAUTION

• Keep the antenna as far away as possible from the electronic control modules.

• Keep the antenna wire more than 8 in (20 cm) away from the electronic control system harness. Do not route the antenna wire next to any harness.

• Adjust the antenna standing-wave ratio as recommended by the manufacturer.

• Connect the ground wire from the CB radio chassis to the body.

• For details, consult a NISSAN dealer.

    Antenna
    To remove the antenna, hold the bottom of the antenna and turn it counterclockwise. To install the antenna, turn the antenna clockwise and tighten. CAUTION • To avoid damaging or deforming the an ...

    Bluetooth® Hands-Free Phone System
    WARNING • Use a phone after stopping your vehicle in a safe location. If you have to use a phone while driving, exercise extreme caution at all times so full attention may be given to vehicle ope ...

    Other materials:

    B2604 shift position
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2604 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B2604 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, "D ...

    Back door does not opened
    Diagnosis Procedure 1.CHECK BACK DOOR OPENER SWITCH Check back door opener switch. Refer to DLK-513, "Component Function Check". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace the malfunctioning parts. 2.CHECK BACK DOOR OPENER ACTUATOR ...

    C1115 wheel sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT ...